PREPARING TO IRON
1Preparation
1.Remove the case.
2.Pull the electrical cord out only to the length required. Insert the plug all the way into an electrical outlet.
Red tape
120 V AC
•Do not over extend the cord farther than the section marked by this red tape.
2Filling with Water
It is not necessary to pour water into the water tank if not using the steam or water spray features.
1.Press down the steam button to set the iron to the “Dry” position.
2.Remove the tank and fill it with water, up to the mark indicating “FULL”.
While pressing down the release button, remove the tank.
Up to the mark indicating FULL
Fill with tap water
•Regions that have extremely hard water should use a mixture of 50% tap water and 50% distilled water.
•Do not use water treated by household soft water systems, as it contains minerals that are harmful to the iron.
•Do not fill the iron with water in excess of the mark indicating “FULL”. If too much water has been poured in, steam will be discharged continuously whenever the iron is placed on the cradle.
3.Close the inlet/ outlet spout lid, then reinstall the tank onto the iron.
Click!
Push water tank all the way in until it clicks.
5