Maytag W10312952A Non-Use or Storage Care, Moving Care, Reinstalling the Dryer, Water Inlet Hose

Page 14

NON-USE, STORAGE, AND MOVING CARE

Install and store your dryer where it will not freeze. Because some water may stay in the hose, freezing can damage your dryer. If storing or moving your dryer during freezing weather, winterize it.

Non-Use or Storage Care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

3.Turn off the water supply to the dryer. This helps to avoid unintended flooding (due to a water pressure surge) while you are away.

Moving Care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Gas models only: Close shutoff valve in gas supply line.

3.Gas models only: Disconnect gas supply line pipe and remove fittings attached to dryer pipe.

4.Gas models only: Cap the open fuel supply line.

5.Steam models only: Shut off water faucet.

6.Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

7.Make sure leveling legs are secure in dryer base.

8.Use tape to secure dryer door.

For direct-wired dryers:

1.Disconnect power.

2.Disconnect wiring.

3.Steam models only: Shut off water faucet.

4.Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately.

5.Make sure leveling legs are secure in dryer base.

6.Use tape to secure dryer door.

Reinstalling the Dryer

Follow the “Installation Instructions” to locate, level, and connect the dryer.

SPECIAL INSTRUCTIONS

FOR STEAM MODELS

Water Inlet Hose

Replace inlet hose and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hose if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hose, record the date of replacement.

To Winterize the Dryer

1.Unplug dryer or disconnect power.

2.Shut off water faucet.

3.Disconnect water inlet hose from faucet and drain.

To Use the Dryer Again

1.Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet.

2.Plug in dryer or reconnect power as described in the Installation Instructions.

14

Image 14

Contents Use & Care Guide Guide d’utilisation et d’entretien Dryer Safety Electronic DryerPage Worksurface PedestalStack Kit Tips for getting the best performance from your steam dryer Check Your Vent System for Good AIR FlowMaintain good air flow by Control Panel and Features Specialty Cycles Specialty Cycles includeLoad Size Recommendations Temperature Level TimeOptions Cycle Guide Timed Cycles Cycle Drying Default Available Items to dryItems to Cycle Drying Default Available Refresh Cycle Guide Steam CyclesPress POWER/CANCEL Using Your DryerClean the lint screen Load the dryerTo change the drying settings Set any cycle settingsChanging the Sensor Cycle settings to increase drying time Select the desired cyclePress and hold START/PAUSE to begin cycle Additional FeaturesSelect any additional options Remove garments promptly after cycle is finishedDryer Care Moving Care Reinstalling the DryerNon-Use or Storage Care Water Inlet HoseIf you experience Possible Causes Solution Using the BUILT-IN Troubleshooting FeatureTroubleshooting Dryer OperationOther Issues Dryer ResultsMaytag Laundry Warranty This limited warranty does not coverSécurité DE LA Sécheuse Page Surface de travail Piédestal deEnsemble de superposition Circulation d’air adéquate Bouton START/PAUSE mise en marche/pause Tableau DE Commande ET CaractéristiquesMise sous tension/annulation Bouton Reduce Static réduction de l’électricité statique Steam Boost puissance vapeurListe des programmes spéciaux Options ET Réglages À L’ÉCRANProgrammes Spéciaux De séchage Séchage Défaut Disponibles Recommandations concernant le volume de la chargeGuide DE Programmes Programmes DE Détection ProgrammeTempérature Durée Articles àPar Options Sécher De sechage Défaut DisponiblesGuide DE PROGRAMMES-PROGRAMMES Avec Vapeur Nettoyer le filtre à charpie Appuyer sur POWER/CANCEL mise sous tension/annulationUtilisation DE LA Sécheuse Charger la sécheuseProgrammes de détection Sélectionner le programme désiréSélectionner les réglages de programme, si désiré Programmes minutésSélectionner les options de programme supplémentaires Pour changer les réglages de séchageCaractéristiques Supplémentaires Utilisation de la grille de séchageNettoyage de l’intérieur de la sécheuse Nettoyer l’emplacement de la sécheuseEntretien DE LA Sécheuse Retirer la charpie accumuléePrécautions à prendre avant un déménagement Réinstallation de la sécheuseEntretien en cas de non-utilisation ou d’entreposage Sécheuses alimentées par cordon d’alimentationRéutilisation de la sécheuse Tuyau d’arrivée d’eauHivérisation de la sécheuse Appuyer sur Learn More Utilisation DE LA Caractéristique DE Dépannage IntégréeDépannage Fonctionnement de la sécheuseRésultats de la sécheuse Autres problèmesPage Page Garantie DES Appareils DE Buanderie Maytag La présente garantie limitée ne couvre pasSi vous avez besoin de pièces de rechange If you need replacement parts or to order accessoriesOur consultants provide assistance with Nos consultants fournissent ’assistance pour