Maytag W10312956A - SP, W10312952A manual Dryer Care

Page 13

DRYER CARE

CLEANING THE DRYER LOCATION

Keep dryer area clear and free from items that would block the air flow for proper dryer operation. This includes clearing piles of laundry in front of the dryer.

CLEANING THE DRYER INTERIOR

To clean dryer drum

1.Use a mild hand dish detergent mixed at a low concentration with very warm water, and rub with a soft cloth.

2.Rinse well with a wet sponge or towel.

3.Tumble a load of clean clothes or towels to dry drum

OR

Use a microfiber cloth and hot water in a spray bottle to clean the drum and a second microfiber towel to dry.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the rear of the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

REMOVING ACCUMULATED LINT

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified servicer.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

CLEANING THE LINT SCREEN

Every load cleaning

The lint screen is located in the door opening of the dryer. The LCD will display a message to remind you to clean the lint screen after each load. A screen blocked by lint can increase drying time.

To clean:

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

nDo not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

nIf lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements.”

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash:

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with

hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4. Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Reinstall screen in dryer.

13

Image 13
Contents Use & Care Guide Guide d’utilisation et d’entretien Electronic Dryer Dryer SafetyPage Stack Kit PedestalWorksurface Maintain good air flow by Check Your Vent System for Good AIR FlowTips for getting the best performance from your steam dryer Control Panel and Features Specialty Cycles include Specialty CyclesOptions Temperature Level TimeLoad Size Recommendations Items to Cycle Drying Default Available Refresh Cycle Drying Default Available Items to dryCycle Guide Timed Cycles Cycle Guide Steam CyclesClean the lint screen Using Your DryerPress POWER/CANCEL Load the dryerChanging the Sensor Cycle settings to increase drying time Set any cycle settingsTo change the drying settings Select the desired cycleSelect any additional options Additional FeaturesPress and hold START/PAUSE to begin cycle Remove garments promptly after cycle is finishedDryer Care Non-Use or Storage Care Reinstalling the DryerMoving Care Water Inlet HoseTroubleshooting Using the BUILT-IN Troubleshooting FeatureIf you experience Possible Causes Solution Dryer OperationDryer Results Other IssuesThis limited warranty does not cover Maytag Laundry WarrantySécurité DE LA Sécheuse Page Ensemble de superposition Piédestal deSurface de travail Circulation d’air adéquate Mise sous tension/annulation Tableau DE Commande ET CaractéristiquesBouton START/PAUSE mise en marche/pause Steam Boost puissance vapeur Bouton Reduce Static réduction de l’électricité statiqueProgrammes Spéciaux Options ET Réglages À L’ÉCRANListe des programmes spéciaux Guide DE Programmes Programmes DE Détection Recommandations concernant le volume de la chargeDe séchage Séchage Défaut Disponibles ProgrammePar Options Sécher De sechage Défaut Durée Articles àTempérature DisponiblesGuide DE PROGRAMMES-PROGRAMMES Avec Vapeur Utilisation DE LA Sécheuse Appuyer sur POWER/CANCEL mise sous tension/annulationNettoyer le filtre à charpie Charger la sécheuseSélectionner les réglages de programme, si désiré Sélectionner le programme désiréProgrammes de détection Programmes minutésPour changer les réglages de séchage Sélectionner les options de programme supplémentairesUtilisation de la grille de séchage Caractéristiques SupplémentairesEntretien DE LA Sécheuse Nettoyer l’emplacement de la sécheuseNettoyage de l’intérieur de la sécheuse Retirer la charpie accumuléeEntretien en cas de non-utilisation ou d’entreposage Réinstallation de la sécheusePrécautions à prendre avant un déménagement Sécheuses alimentées par cordon d’alimentationHivérisation de la sécheuse Tuyau d’arrivée d’eauRéutilisation de la sécheuse Dépannage Utilisation DE LA Caractéristique DE Dépannage IntégréeAppuyer sur Learn More Fonctionnement de la sécheuseAutres problèmes Résultats de la sécheusePage Page La présente garantie limitée ne couvre pas Garantie DES Appareils DE Buanderie MaytagOur consultants provide assistance with If you need replacement parts or to order accessoriesSi vous avez besoin de pièces de rechange Nos consultants fournissent ’assistance pour