3.Remove the 2 screws that hold the handle bracket to the door.
4.Move hinge to the other side and reattach with the 4 screws removed in Step 2.
5.Move handle bracket to the other side and reattach with the 2 screws removed in Step 3.
6.Set the inner door assembly aside.
Reinstalling the door
1.Check for fingerprints on the glass. Clean the glass if necessary.
2.Place the inner door assembly into the outer door assembly. Align the hinge in the opening on the side. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge.
3.Reassemble the inner and outer door assemblies with the 6 screws.
4.Replace the 2 handle screws for the door handle of the door assembly.
5.Remove the plug strip or label.
Style 1: Remove the plug strip.
■Use a small
Style 2: Remove the label.
■Peel off the label located on the opposite side of the door opening covering the hinge mounting holes. Apply the label over the original hinge holes.
6.Insert a screw in the second opening from the top of the hinge opening and partially tighten. Hang the door by placing the top hinge keyhole over the second screw head and tighten the screw. By putting this screw in first, the door will hang in place while you insert and tighten the remaining
4 screws.
A
B
C |
A. Dryer door
B.Dryer
C.Insert this screw first.
7.Close the door and check that it latches securely.
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.Check the dryer’s final location. Be sure the vent is not crushed or kinked.
5.Check that the dryer is level. See “Level Dryer.”
6.In the U.S.A.
■For power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on power.
In Canada
■Plug into a grounded 4 prong outlet. Turn on power.
7.Remove any protective film or tape remaining on the dryer.
8.Read “Dryer Use.”
9.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
10.Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
■Controls are set in a running or “On” position.
■Start button has been pushed firmly.
■Dryer is plugged into a grounded outlet and/or electrical supply is on.
■Household fuse is intact and tight, or circuit breaker has not tripped.
■Dryer door is closed.
18