GE RPT 301 Command Function Measurement, Set-up, User calibration, CR Crlf Command Terminators

Page 20

12	RPT 301 User Manual

Command Summary Table

Command		Function
	Measurement

R		Return stored reading
		Return stored reading
<CR>	*	Return stored reading
G		Get New Reading
		Auto send reading
A		Auto send reading
		Auto send from power-up
X		Auto send from power-up

	Set-up

U		Set units
		Set filter
F		Set filter

B		Set reading resolution
		Set communication parameters
O		Set communication parameters

S		Status
		Identity
I		Identity

	User calibration

C		User calibration (linearity)

PChange protection PIN

CR CRLF Command Terminators

*Short form of the 'R<CR>' command

K177 Issue No. 3

Image 20

Contents RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Specification DimensionsDescription AccuracyPower supply Pressure measurementData Communications Pressure connectionAccessories Mounting the Instrument Figure Pressure ConnectionInstrument Dimensions Electrical Connection Communication connectionsConnections for remote on/off control Communications Changing the communication interface standard Figure LK1 LK2 PL3PL1 RPT ScreeningCommand Summary System OperationCommand Function Measurement CR Crlf Command TerminatorsSet-up User calibrationCommand Strings General Command FormatSingle commands Page Error Message General Reply FormatData out of range Detailed Command Definitions Measurement Commands Return stored readingGet reading Auto send readingAuto Send from switch-on Set-up Commands Unit Set-upFilter Set-up Command F, step, averageSet Resolution Set Communications Options Identity Command I,S/PIN, Name ValueCR formatStatus Calibration Check User Calibration Linearity/Drift CompensationPIN Change PIN PIN, New PINLED Indicator Diagnostic ModeDiagnostic Mode GeneralCleaning Approved Service Agents