GE RPT 301 user manual Change PIN, PIN, New PIN

Page 33

RPT 301 User Manual

25

P - Change PIN

This command changes the PIN (Personal Identification Number) that protects the calibration data. The instrument is shipped with the PIN

000.If the PIN is lost, the default (000) may be restored by fitting the ‘default’ link and switching off and then on.

Note: Restoring the defaults restores ALL of the factory settings including the communication parameters.

Command:	P, PIN, New PIN
Where:	PIN is the existing 3-digit code (000 to 999) and New
	PIN is the replacement PIN.
Reply:	None
Result:	PIN is replaced by New PIN

K177 Issue No. 3

Image 33

Contents RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Dimensions SpecificationDescription AccuracyPressure measurement Power supplyData Communications Pressure connectionAccessories Pressure Connection Mounting the Instrument FigureInstrument Dimensions Communication connections Electrical ConnectionConnections for remote on/off control Changing the communication interface standard Figure CommunicationsLK1 LK2 PL3PL1 Screening RPTSystem Operation Command SummaryCR Crlf Command Terminators Command Function MeasurementSet-up User calibrationGeneral Command Format Single commandsCommand Strings Page General Reply Format Error MessageData out of range Return stored reading Detailed Command Definitions Measurement CommandsGet reading Auto send readingAuto Send from switch-on Unit Set-up Set-up CommandsCommand F, step, average Set ResolutionFilter Set-up Set Communications Options Command I,S/PIN, Name ValueCR format StatusIdentity User Calibration Linearity/Drift Compensation Calibration CheckPIN PIN, New PIN Change PINDiagnostic Mode LED IndicatorDiagnostic Mode GeneralCleaning Approved Service Agents