GE RPT 301 user manual

Page 22

14	RPT 301 User Manual

2.U, O; G; R; G; R; U, 16; G; R; G; R; G; R; A, 100

Reply: Reading 1 mbar Reading 2 mbar Reading 3 psi Reading 4 psi Reading 5 psi

Then at 100 second intervals - Reading psi

This command string sets the instrument units to mbar, returns two consecutive readings, changes units to psi, returns three consecutive readings and then selects auto-send mode with a period of 100 seconds between readings.

Command String Limitations

Auto-send mode and diagnostics mode are cancelled when a further command is received, this should be used at the end of a command string.

Note: The C, L and T commands are interactive and are not suitable for multiple commands.

K177 Issue No. 3

Image 22

Contents RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Description SpecificationDimensions AccuracyData Communications Power supplyPressure measurement Pressure connectionAccessories Mounting the Instrument Figure Pressure ConnectionInstrument Dimensions Electrical Connection Communication connectionsConnections for remote on/off control Communications Changing the communication interface standard FigureLK1 LK2 PL3PL1 RPT ScreeningCommand Summary System OperationSet-up Command Function MeasurementCR Crlf Command Terminators User calibrationSingle commands General Command FormatCommand Strings Page Error Message General Reply FormatData out of range Get reading Detailed Command Definitions Measurement CommandsReturn stored reading Auto send readingAuto Send from switch-on Set-up Commands Unit Set-upSet Resolution Command F, step, averageFilter Set-up Set Communications Options Status Command I,S/PIN, Name ValueCR formatIdentity Calibration Check User Calibration Linearity/Drift CompensationPIN Change PIN PIN, New PINDiagnostic Mode LED IndicatorDiagnostic Mode GeneralCleaning Approved Service Agents