GE RPT 301 user manual RPT Digital Output Pressure Transducer K177

Page 3

RPT 301

Digital Output Pressure Transducer

User Manual

K177

© Druck Limited 1998

This document is the property of Druck Limited and may not, either in part or whole, be copied or otherwise reproduced, communicated in any way to third parties, nor stored in any Data Processing System, without the express written authority of Druck Limited.

K177 Issue No. 3

Image 3

Contents RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Accuracy SpecificationDimensions DescriptionPressure connection Power supplyPressure measurement Data CommunicationsAccessories Pressure Connection Mounting the Instrument FigureInstrument Dimensions Communication connections Electrical ConnectionConnections for remote on/off control Changing the communication interface standard Figure CommunicationsLK1 LK2 PL3PL1 Screening RPTSystem Operation Command SummaryUser calibration Command Function MeasurementCR Crlf Command Terminators Set-upGeneral Command Format Single commandsCommand Strings Page General Reply Format Error MessageData out of range Auto send reading Detailed Command Definitions Measurement CommandsReturn stored reading Get readingAuto Send from switch-on Unit Set-up Set-up CommandsCommand F, step, average Set ResolutionFilter Set-up Set Communications Options Command I,S/PIN, Name ValueCR format StatusIdentity User Calibration Linearity/Drift Compensation Calibration CheckPIN PIN, New PIN Change PINGeneral LED IndicatorDiagnostic Mode Diagnostic ModeCleaning Approved Service Agents