GE RPT 301 user manual Abbreviations and Symbols

Page 6

ii	RPT 301 User Manual

Abbreviations and Symbols

The following abbreviations are used in this manual.

Note: Abbreviations are the same in the singular and plural.

EMC	electromagnetic compatibility
FS	full-scale
IEC	International Electrical Council
inHg	inch of mercury
kg/cm2	kilogram per centimetre squared
kPa	kilo Pascal
mA	milli Ampere
mm	milli metre
NL, H & R	non-linearity, hysteresis and repeatability
PCB	printed circuit board
psi	pound per square inch
RPT	resonant pressure transducer
V	Volt
VA	Volt amp

The following symbols are used in this manual

Hazard, a warning highlighting a danger that would result in injury. Also a marking on the instrument referring the user to this publication.

This symbol, on the instrument or in the manual, indicates a static sensitive component.

This product meets the essential protection requirements of CE the relevant EEC directives. Further details of applied stand-

ards may be found in the product specification.

K177 Issue No. 3

Image 6

Contents RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Description SpecificationDimensions AccuracyData Communications Power supplyPressure measurement Pressure connectionAccessories Mounting the Instrument Figure Pressure ConnectionInstrument Dimensions Electrical Connection Communication connectionsConnections for remote on/off control Communications Changing the communication interface standard FigureLK1 LK2 PL3PL1 RPT ScreeningCommand Summary System OperationSet-up Command Function MeasurementCR Crlf Command Terminators User calibrationGeneral Command Format Single commandsCommand Strings Page Error Message General Reply FormatData out of range Get reading Detailed Command Definitions Measurement CommandsReturn stored reading Auto send readingAuto Send from switch-on Set-up Commands Unit Set-upCommand F, step, average Set ResolutionFilter Set-up Set Communications Options Command I,S/PIN, Name ValueCR format StatusIdentity Calibration Check User Calibration Linearity/Drift CompensationPIN Change PIN PIN, New PINDiagnostic Mode LED IndicatorDiagnostic Mode GeneralCleaning Approved Service Agents