| PowerLogicTM EM4800 Series | |
04/2011 |
| Installation |
|
| |
Mounting the PowerLogic EM4800 meter | Figure 4 shows the general mounting layout for metering 120V/208V wye | |
| services, and Figure 5 shows the general mounting layout for metering | |
| 347V/600V wye services. | |
| 1. | Remove the front cover from the meter by removing the four screws |
|
| with a #2 Phillips screwdriver. Retain the cover and screws for later |
|
| |
| 2. | Mount the PowerLogic meter on the wall and secure it by inserting a |
|
| screw in each mounting keyhole and tightening the screws. |
| 3. | Mount the shorting block enclosure on the wall as shown in Figures 4 |
|
| and 5. Secure it by inserting a screw in each mounting keyhole and |
|
| tightening the screws. |
| 4. | Install the conduit for voltage and current connections. |
| In Figure 4, the meter is powered and takes its sense voltage directly from a | |
| breaker within the panel. |
© 201 Schneider Electric All Rights Reserved | 9 |