PowerLogicTM EM4800 Series | |
| 04/2011 |
|
|
Hazard Categories and Special Symbols
Read these instructions carefully and look at the equipment to become familiar with the device before trying to install, operate, service or maintain it. The following special messages may appear throughout this bulletin or on the equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.
The addition of either symbol to a “Danger” or “Warning” safety label indicates that an electrical hazard exists which will result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER
DANGER indicates an imminently hazardous situation which, if not avoid- ed, will result in death or serious injury.
| WARNING |
|
|
| WARNING indicates a potentially hazardous situation which, if not avoid- |
| ed, can result in death or serious injury. |
|
|
| CAUTION |
|
|
| CAUTION indicates a potentially hazardous situation which, if not avoid- |
| ed, can result in minor or moderate injury. |
|
|
| CAUTION |
|
|
| CAUTION, used without the safety alert symbol, indicates a potentially |
| hazardous situation which, if not avoided, can result in property damage. |
| NOTE: Provides additional information to clarify or simplify a |
| procedure. |
PLEASE NOTE | Electrical equipment should be installed, operated, serviced, and maintained |
| only by qualified personnel. No responsibility is assumed by Schneider |
| Electric for any consequences arising out of the use of this material. |
FCC NOTICE | This equipment has been tested and found to comply with the limits for a |
| Class B digital device, pursuant to part 15 of the FCC Rules. These limits are |
| designed to provide reasonable protection against harmful interference when |
| the equipment is operated in a commercial environment. This equipment |
| generates, uses, and can radiate radio frequency energy and, if not installed |
| and used in accordance with the instruction manual, may cause harmful |
| interference to radio communications. Operation of this equipment in a |
| residential area is likely to cause harmful interference in which case the user |
| will be required to correct the interference at his own expense. This Class B |
| digital apparatus complies with Canadian |
© 201 Schneider Electric All Rights Reserved