Apollo IMY instruction manual Module #2 Program Temperature Display Offset and Slope

MODULE #1 - PROGRAM THERMISTOR TYPE, TEMPERATURE SCALE (F OR C) AND DECIMAL POINT POSITION

Select the desired Thermistor type by pressing the “UP” or “DOWN” button.

“tYPE” < > “400” 400 = 400 Series, 2,252 ohm “700” 700 = Thermolinear￿ Series

Select the desired temperature scale by pressing the “UP” or “DOWN” button.

“SCALE” < > “F” “C”

Select the desired decimal point location by pressing the “UP” or “DOWN” button.

“dECPNt” < > “0” “0.0”

MODULE #2 - PROGRAM TEMPERATURE DISPLAY OFFSET AND SLOPE

If the totalizer option is installed, the offset and slope can be programmed for various temperature probe differences. See the Offset and Slope Display Temperature section for more details.

Select the desired temperature display slope value by pressing the “UP” or the “DOWN” button.

“SLOPE” < > “0.0001” to “10.0000” (ex. 1.0309)

Select the desired temperature display offset value by pressing the “UP” or the “DOWN” button.

“OFFSEt” < > “-999” to “9999” (ex. -17.5)

-8-