Furuno FR-2115/2125 manual Plate, Connection of display unit to control head

4.Replace the cable assy. with cable assy. UL2464SB2-0P/1P (10 m, supplied) as below and reassemble the control head.

5. Attach warning label to the bottom plate.

P312 FX Connector

KB	BOTTOM
PLATE

Upset Screw

M6X12 (2 pcs.)

KB Clamp

Handle

Attach warning label

J314		J317	(underside)
J312
		(underside)
	(underside)

Earth Wire

P314 XH3P

Screw

M4X8 (8 pcs.)

Lay cable in slot.

Replace with	Spacer Pan-head Screw M4X8 (2 pcs.)
cable assy. in	Be careful not to pinch cable between
kit.	KB clamp and spacer.

Figure 1-14 Control head

Connection of display unit to control head

1.Attach the handle to the handle plate, using the screws for the handle and bottom cover of the control head.

2.Attach the handle plate to location where the KB arms were fastened.

3.Pull the monitor toward you until you hear click.

4.Lead in the cable assy. (option) from the rear entrance of the display unit. See Chapter 2.

5.Raise the monitor and fix the stay.

6.Inside the display unit, fasten ground wire of the cable assembly with an M4 screw on the chassis.

1-11