Furuno FR-2115/2125 manual Leading in cables to the display unit

Leading in cables to the display unit

The cable clamp may be positioned within the display unit (default arrangement), outside the display unit or at the bottom of the display unit (when using console mount, for example). When the cable clamp is located outside or beneath the dis- play unit, use the bottom clamp front plate and bottom clamp rear plate (supplied with installation materials).

Also, use the shielding foam (supplied) to protect the noise radiation.

Cable fed from rear of display unit (Default)

Nav equipment	Slave display
(Gyrocompass)

Panhead screw

M4X8

Hex bolt

M5X12 SUS 2pcs

(D) Rear clamp plate

Keyboard

Log

Navigation

Hex bolt
M5X35 SUS 2pcs	(C) Signal clamp
	(Aluminum)

PWRSCAN

External CRT

Cable position in clamp (Display unit, rear view)

Rubber plug

*When no log or nav equipment is installed,

insert rubber plug (supplied) to the left of keyboard cable to hold the cable in place.

Hex bolt

M5X35 SUS 2pcs

(B) Power clamp

(Aluminum)

(A) Rear clamp base

(Construction of

cable clamp)

(D) Rear clamp plate

	Make sure foam contacts rear chassis.
(C) Signal cable	Rear cable entrance
(Aluminum)

(B) Power clump (Aluminum)

	Cable
(A) Rear clamp base	Shielding foam	(Display unit, rear view)

(Display unit, right-hand side view)

Figure 2-12 Default cable clamp position

•Place shielding foam between cables, and then attach foam to aluminum clamps.

•Fill unused clamp holes with shielding foam.

2-8