Vector VEC054D owner manual Important Safety Instructions, Important Cable Information

Page 3

90548011 VEC054D INVERTER.qxp 3/6/09 10:41 AM Page 2

IMPORTANT SAFETY INSTRUCTIONS

WARNING: This product or its power cord contains lead, a chemical known to the State of California to cause cancer and birth defect or other reproductive harm. Wash hands after handling.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:

Do not connect to AC distribution wiring.

Do not make any electrical connections or disconnections in areas designated as IGNITION PROTECTED. This unit is NOT approved for ignition protected areas.

NEVER immerse the unit in water or any other liquid, or use when wet.

Do not insert foreign objects into the AC outlet or the USB outlet (if provided).

WARNING: TO REDUCE THE RISK OF FIRE:

Do not operate near flammable materials, fumes or gases.

DO NOT expose to extreme heat or flames.

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

Remove appliance plug from outlet before working on the appliance.

DO NOT attempt to connect or set up the unit or its components while operating your vehicle. Not paying attention to the road may result in a serious accident.

ALWAYS use the inverter where there is adequate ventilation. Do not block ventilation slots.

ALWAYS turn the inverter OFF by disconnecting it from the power source when not in use.

Make sure the nominal powering voltage is 12 volts DC.

When using this unit in a vehicle, check the vehicle owner’s manual for maximum power rating and recommended output. Do not permanently install in engine compartment — install in a well ventilated area.

Do not use with positive ground electrical systems*. Reverse polarity connection will result in a blown fuse and may cause permanent damage to the inverter and will void warranty.

*The majority of modern automobiles, RVs and trucks are negative ground.

Keep in mind that this inverter may not operate very high wattage appliances or equipment that produce heat. Refer to “Appliance Consumption” chart in this manual.

Do not open the inverter — there are no user-serviceable parts inside.

Do not use this inverter with medical devices. It is not qualified for medical applications.

Keep away from children. This is not a toy!

Install and operate unit only as described in this Instruction Manual.

Do not use this inverter on a watercraft. It is not qualified for marine applications.

Check unit periodically for wear and tear. Take to a qualified technician for replacement of worn or defective parts immediately.

IMPORTANT CABLE INFORMATION:

Substantial power loss and reduced battery operating time results from inverters installed with cables that are not able to supply full power. Symptoms of low battery power can result from cables that are either excessively long or an insufficient gauge. The installer/operator should be especially aware of the requirements to maintain secure, tight, electrical connections and provide strain relief for DC cables and appliance wiring. Cable insulation must be the appropriate type for the environment.

WARNING: TO REDUCE THE RISK OF FIRE:

Do not operate near flammable materials, fumes or gases.

DO NOT expose to extreme heat or flames.

Ensure all cables and connections are tightly secured.

CAUTION: TO AVOID DAMAGE TO THIS INVERTER OR EQUIPMENT YOU INTEND TO USE WITH THIS INVERTER: For Temporary Installation, only use the Black & Decker/Vector Cable Set identified in the “Installation” and “Specifications” sections of this Instruction Manual. Permanent Installation must be performed by a professional as specified in the “Installation” section of this Instruction Manual.

• Read And Understand This Instruction Manual Before Using This Unit.

SAVE THESE INSTRUCTIONS

2

Image 3
Contents VEC054D Maxx SsttmVolts Minimum Gage for Cord Sets Safety Guidelines / DefinitionsImportant Cable Information Important Safety InstructionsIntroduction FeaturesMaxx SST Features Front View Diagram Back View DiagramPower Inverter Output Waveform Appliance Power ConsumptionPrinciple of Operation 880 Appliance Consumption in Amps and Watts ChartAppliance AMPS@ WATTS@ 120VACRuntime Power Source RequirementsDetermining Battery Size Operating InstructionsProtective Features InstallationBattery Operating Times Installation Procedures Temporary InstallationOperating Environment Operating Tips Permanent Installation#2AWG power source cables must not exceed 6 feet in length Connection To LoadTroubleshooting Common Audio/Visual ProblemsProblem Solution Fuse Replacement Preventive Maintenance Fault Protection and Troubleshooting GuideResetting the Unit Care and MaintenanceSpecifications AccessoriesYear Limited Warranty Program Compact DE 2000 W Lignes Directrices EN Matière DE SÉCURITÉ/DÉFINITIONS Avertissement Pour Réduire LE Risque D’INCENDIE Directives DE Sécurité ImportantesAvertissement Pour Réduire LE Risque DE Blessures Conserver CES DirectivesCaractéristiques Renseignements Importants SUR LE CâbleForme d’onde de sortie du convertisseur continu-alternatif Commandes et fonctionsCaractéristiques du Maxx SST Principe DE FonctionnementProduits incompatibles Consommation Énergétique DES Appareils ÉlectriquesAppareil Puissance À120 V C.A Durée de fonctionnement FonctionnementExigences relatives à la source d’alimentation Détermination de la taille de la batterieDurées de fonctionnement des batteries Caractéristiques de sécuritéMode d’installation Installation temporaireEnvironnement d’exploitation Installation permanente Conseils d’utilisation Connexion à la chargeGuide de protection contre les défaillances et de dépannage Problème SolutionDépannage Problèmes audiovisuels communsRangement Remplacement de fusibleAccessoires Réenclenchement des circuits de l’appareilProgramme DE Garantie Restreinte DE Deux ANS La liberté de la PuissanceCordless,MAXXRechargeableSST Normas DE SEGURIDAD/DEFINICIONES Advertencia Para Reducir EL Riesgo DE Incendio Instrucciones Importantes Sobre SeguridadAdvertencia Para Reducir EL Riesgo DE Descarga Eléctrica No conecte al cableado de distribución de CAControles y funciones Conserve Estas InstruccionesIntroducción CaracterísticasComparación de onda senoidal modificada y onda senoidal Características de Maxx SSTPrincipio DE Operación La forma de onda de salida del conversor eléctricoATENCIÓN. Para Reducir EL Riesgo DE Daños a LA Propiedad Consumo DE Energía DE LOS ArtefactosArtefacto Cuadro DEL Consumo EN Amperios Y Vatios DE ArtefactosInstrucciones DE Operación Requisitos de la fuente de energíaTiempo de funcionamiento Cómo determinar el tamaño de la bateríaCaracterísticas de protección InstalaciónTiempos de funcionamiento de la batería Entorno de operación Procedimientos de instalaciónInstalación temporaria Instalación permanente Diagrama de configuración de baterías permanentesConexión a la carga Sugerencias de operaciónNota sobre el uso del control remoto se vende por separado Problema Solución Detección DE ProblemasProblemas visuales/de audio frecuentes Guía de protección de fallas y detección de problemasMantenimiento preventivo Reinicio de la unidadAlmacenamiento Reemplazo de fusiblesCat No. VEC054D Form No MAR La libertad de la Energía
Related manuals
Manual 2 pages 33.99 Kb