Multiquip HHXG5 operation manual Inspection, Engine Oil Level, Gearbox Oil Level, Fuel

Page 22

INSPECTION

This section is intended to assist the operator with the initial start-up of the HHX. It is extremely important that

the gearbox, and refill with ISO 220 A GMA GR 5 EP oil.

this section be read carefully before attempting to use the trowel in the field.

DO NOT use your ride-on power trowel until this section is thoroughly understood.

WARNING

Failure to understand the operation of the HHX could result in severe damage to the trowel or personal injury.

FILL PLUG

SIGHT GLASS (OIL CHECK)

DRAIN PLUG

Figure 8. Gearbox Oil Plugs

See Figure 2, Figure 3, and Figure 4 for the location of any control or indicator referenced in this manual.

Engine Oil Level

1.Pull the engine oil dipstick from its holder.

2.Determine if engine oil is low (Figure 7), add correct amount of engine oil to bring oil level to a normal safe level (Table 4)..

CAUTION

DO NOT overfill engine oil. Oil level should not be above the top fill line.

DIPSTICK

SAFE

OPERATING

MAXLEVEL

ADD OIL

MIN

Figure 7. Engine Oil Dipstick

Gearbox Oil Level

1.Check the gearbox oil level in both gearboxes by viewing the sight glass at the rear of the gearbox. See Figure 8.

2.The oil level of the gear box should be at the half-way point of the sight glass. The gear box oil capacity is 1 U.S. Gallon, (3.79 liters). If additional oil is required, unscrew the oil fill plug located on top of

Fuel

To determine if the engine fuel is low, view the sight gauge on the side of the fuel tank. If fuel level is low, fill with unleaded gasoline.

WARNING

Handle fuel safely. Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. Do not attempt to refuel the ride-on trowel if the engine is hot or running.

WARNING

Never store the ride-on trowel with fuel in the tank for any extended period of time. Drain fuel into an appropriate recepticle. Drain by opening the fuel petcock at the bottom of the tank. Always clean up spilled fuel immediately.

HYDRAULIC FLUID FILTER

To determine if the hydraulic fluid filter needs to be changed, view the sight gauge above the hydraulic filter located beneath the foot platform.. If the gauge reads in the red area, indicating a fiter by-pass condition, the filter needs to be replaced.

page 22 — HHXg5 RIDE-ON TROWEL • operation manual — rev. #1 (10/25/10)

Image 22
Contents Model HHXG5 Proposition 65 Warning Silicosis Warning Silicosis/Respiratory WarningsRespiratory Hazards Table of Contents HHXG5 Ride-On TrowelPage Training checklist CompletelyDaily pre-operation checklist Daily pre-Operation ChecklistSafety Information SaFeTY meSSageSGeNeRaL SaFeTY Order Form PT-160 TROWeL SaFeTYENgINe SaFeTY Before servicing equipmentBaTTeRY SaFeTY FueL SaFeTY„ Use well-insulated gloves when picking up the battery Lifting TRaNSpORTINg SaFeTYTOWINg SaFeTY „ aLWaYS shutdown engine before transportingENvIRONmeNTaL SaFeTY DIMENSIONS/SPECIFICATIONS Trowel HHX SpecificationsSpecifications Engine FuelGeneral Information Controls and Indicators HHXG5 Controls and Indicators FrontHHXG5 Controls and Indicators Rear HHXG5 Controls and Indicators Clamshell Open Engine Components Gasoline Linked to the accelerator systemTrowel Setup Instructions SetupBattery Setup Gearbox Oil Level InspectionEngine Oil Level FuelOperation Starting the EngineSteering Control Joystick Directional PositioningBlade Pitch Matching Blade Pitch for Both Sets of BladesWeekly 30-40 Hours MAINTENANCEMaintenance Schedule Daily 8-10 Hours Monthly 100-150 HoursOil Filter 300 Hours Air Cleaner DailyChanging Engine Oil And Filter Fuel FilterOil And Fuel Lines Battery/Charging SystemOil/Water Separator Radiator/Cooling SystemChecking The Drive Belt MAINTENANCE old style clutchRemoving the Drive Belt Installing the Drive Belt Using New Drive Belt Expanding Lower Drive PulleySpare Drive Belt Replacement Left Side GearboxHow It Works Figure Springs High Engine RPM Driven PulleyClutch Spring Driven Pulley CAM Bracket Moveable Fixed FaceMAINTENANCE new style clutch Belt measurementInstalling Drive Belt Lower drive pulleyHow it works Single Pitch MAINTENANCE TrowelBlade Pitch Adjustment Procedure Twin PitchTMChanging Blades Steering AdjustmentClean-Up „„Do the pitch control towers rock back and forth?Place the trowel in a FLAT, Level area Trowel Arm AdjustmentAssembly Distance from the lower wear plateTrowel Arm Removal Trowel Blade RemovalRemove the trowel arm from the spider plate Locate the trowel arm adjustment tool P/N Checking Trowel Arm StraightnessInstalling Pans Onto Finisher Blades Re-AssemblyLifting/Crush Hazard.DO not lift trowel with pans attached Verify the hydraulic fluid level is correct Checking Steering PressureHydraulic Steering Pressure Move the throttle lever to Full engine RPMSteering Pressure Adjustment Steering Pressure CheckDecommissioning trowel Decommissioning Trowel/ComponentsWiring Diagram Engine StarterConnector Orientation Front View Relay Orientation Troubleshooting Symptom Possible problem SolutionTroubleshooting Ride-On Trowel Troubleshooting engine Air cleaner dirty? Clean or replace air cleaner HERE’S HOW to GET Help
Related manuals
Manual 68 pages 56.17 Kb