2.0 JACKS AND CONTROL FEATURES
2.1. FRONT PANEL:
INPUT: Input sensitivity is broad enough to handle guitars equipped with humbuckers, active pickups, or single coils.
CLEAN VOL: Determines the CLEAN channel's volume. Depending on the type of pickups in your instrument, the amp will begin to clip somewhere around the 12 o'clock setting (SoftClick).
CHANNEL SELECT: This channel selector switch activates either the CLEAN or LEAD channel. The LEAD channel is active when the button is pressed.
RED LEAD LED: The red LED illuminates when the LEAD channel is active.
LEAD GAIN: Controls the amount of distortion in the LEAD channel.
LEAD MASTER: Determines the LEAD channel volume level in relation to the CLEAN channel volume level.
EQ SECTION: Common BASS, MID and TREBLE controls for the both channels. MID and TREBLE controls influence each other, as is standard in tube amps: if you boost the treble, the mids are cut and vice versa. This
REVERB: Controls how much integrated reverb is added to the signal. Reverb is automatically adjusted for each chan- nel when you switch channels.
MASTER: Controls the amp‘s master volume level. The LINE OUT signal is unaffected by the MASTER control.
LINE OUT: Use this jack to feed the signal to the input of an FX processor. You can also route the signal to a second power amp or through a RED BOX to a mixing console.
LINE IN: If you are sending the LINE OUT signal to an FX processor, connect the output from that processor to this jack.
FOOTSWITCH: This jack is for a standard footswitch (e.g. Hughes & Kettner
PHONES: Headphone jack. The speaker is automatically switched off when a plug is inserted into this jack.
2.2 REAR PANEL:
MAINS: Connect the included
ENGLISH
7 |