Plantronics MX10 manual Power source, Head Set when the batteries are low

Switcher.biling.ii-25 11/4/98 7:58 PM Page vi

P A R T	I	easy steps
		install
		in5
		PLUG INTO POWER SOURCE
		CONNECT TO PHONE AND
		HEADSET
		SET DEFAULT SETTINGS
		SET TELEPHONE/AMPLIFIER
		COMPATIBILITY SWITCH
		CONNECT TO AN AUDIO
		DEVICE

vi

I N S T A L L A T I O N S T E P S

S T E P 1 plug into
power source
The AC power supply is shown installed and
plugged in to a standard wall socket on the
Installation Overview (see page v).
The Switcher amplifier requires power to work
with most phones.
Power is not required for:
• Lucent Merlin®, System 75/85 phones
• Lucent Definity® and 8400 series phones
Installing batteries
We recommend an AC power supply (included).
Two AA alkaline batteries (not included) may
also be used, but batteries will need to be
replaced frequently.
1. Remove the Battery Access Door located on the
side of the amplifier by placing your thumb on the
door and pushing down.
2. Install two AA alkaline batteries and replace the
door.
3. You will hear three “beeps“ through	the head-
set when the batteries are low.
e	n g l i s h	1