Plantronics MX10 manual While leaving your headset in place, Incoming Volume Thumbwheel is set to

Switcher.biling.ii-25 11/4/98 7:58 PM Page 2

I N S T A L L A T I O N S T E P S

S T E P 2 attach to

phone and headset

1. Unplug your telephone’s handset cord from the telephone base.

2. Plug your telephone’s handset cord into the Switcher amplifier handset jack ( ).

3. Connect your telephone base to the Switcher amplifier telephone jack ( ) using the short curly cord. On your telephone base, plug the short curly cord into the outlet normally used for your handset.

4. Plug the headset cord into the Quick Disconnect™ (QD) module on the long curly cord coming from the front of the amplifier.

	The QD will allow you to disconnect the headset
	from the amplifier when you are not using the
	phone, or need to move away from the amplifier,
2	while leaving your headset in place.

I N S T A L L A T I O N S T E P S

S T E P 3 set default

settings

These are the default settings for headset use.

1. Headset/Handset Selector is switched to

Headset ( ).2

3

4

5

6

2. Telephone/Computer Audio Switch is released

(no colored indicator showing).	2
	4
	3

	5
3. Microphone Switch is released	6
(no colored indicator showing).

4. Incoming Volume Thumbwheel is set to 4.

5. The Outgoing Volume Control has been pre-set.	2
	3
	5
	4
You can adjust it when you place your first call	6
(see page 6).
e n g l i s h	3