Korg KONTROL49 owner manual MOD MOD Wheel assignment, KBD Keyboard, PAD Pad

Operation–Setting mode

	KBD (Keyboard)
	The controller will specify the keyboard velocity.
	In Play mode, the main display will indicate “KyVel---” when you
	operate the Pitch Bend (or Mod Wheel) controller.
	PAD (Pad)
	The controller will specify the pad velocity. In this case, the velocity
	values being controlled by the Pitch Bend (or Mod Wheel) controller
	are for the note messages transmitted on the MIDI channel specified
	for the pads.
	In Play mode, the main display will indicate “PdVel---” when you
	operate the Pitch Bend (or Mod Wheel) controller.
3	Press the [ENTER] key.
	The setting will be updated, and you will return to Play mode.

If you want to keep the changes you’ve made, save them in Scene mode. If you turn off the power or select a different scene without saving, your changes will be discarded. For details, see “Scene mode–[16] WRITE” (☞p.55).

■Assigning a control change

If you chose CtrlChg# for “Message Select,” use “Control Change Select” to select a control change, and then proceed to “MIDI Channel” (MIDI channel setting).

1	Press the OCTAVE SHIFT/CURSOR [®] key to move to “Control
	Change Select” (select the control change number).

(Red) (Green)

2	Use the main encoder or pads to select the desired control change
	number in a range of 0–127.

3	Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “MIDI
	Channel” (specify the MIDI channel).

(Green) (Green)

4	Use the main encoder or the pads to select the MIDI transmit channel.
	The range is 1–16 (ch).
5	Press the [ENTER] key.
	The setting will be updated, and you will return to Play mode.

If you want to keep the changes you’ve made, save them in Scene mode. If you turn off the power or select a different scene without saving, your changes will be discarded. For details, see “Scene mode–[16] WRITE” (☞p.55).

[6] MOD (MOD Wheel assignment)

Here you can select a message to assign to the Mod Wheel controller, and select the MIDI channel on which the messages will be transmitted.

You can assign aftertouch, velocity, or control change (CC#) messages to the Mod Wheel controller.

1	Hold down the [SETTING] key and press pad [6].
	Now you can specify the Mod Wheel assignment, and the [SETTING]

key and pad [6] will light. The main display indicates “Assignment Select” (select the assignment).

30