[10] PEDAL (Pedal assignment)
Here you can assign a MIDI message to a foot controller or expression pedal connected to the rear panel PEDAL jack, and specify the MIDI transmission channel.
You can assign master volume, foot pedal, portamento time, volume, pan, expression, or control change (CC#) messages to the pedal.
1 | Hold down the [SETTING] key and press pad [10]. |
| Now you can make pedal assignments, and the [SETTING] key and |
pad [10] will light. The main display indicates “Message Select” (select the MIDI message).
2 Use the main encoder to select the MIDI message you want to assign.
NoAssign
No MIDI message will be assigned to the switch. If you choose NoAssign, press the [ENTER] key (blinking) to apply the setting. (☞Step 5)
MastrVol (Master Volume)
Assign master Volume. Master Volume messages [F0, 7F, 7F, 04, 01, vv, mm, F7] (device ID fixed at 7Fh) will be transmitted. In Play mode, the main display will indicate
FootPdl (Foot Pedal)
Foot pedal (CC#04) messages will be assigned to the pedal. Fully advancing the pedal will transmit a value of 127, and fully returning it will transmit a value of 0. In Play mode, the main display will indicate
PortaTm (Portamento Time)
Portamento (CC#05) messages will be assigned to the pedal.
| Fully advancing the pedal will transmit a value of 127, and fully |
| returning it will transmit a value of 0. In Play mode, the main display |
| will indicate |
| Volume (Volume) |
| Volume (CC#07) messages will be assigned to the pedal. |
| Fully advancing the pedal will transmit a value of 127, and fully |
| returning it will transmit a value of 0. In Play mode, the main display |
| will indicate |
| Pan (Panpot) |
| Panpot (CC#10) messages will be assigned to the pedal. |
| Fully advancing the pedal will transmit a value of 127, and fully |
| returning it will transmit a value of 0. In Play mode, the main display |
| will indicate |
| Express (Expression) |
| Expression (CC#11) messages will be assigned to the pedal. |
| Fully advancing the pedal will transmit a value of 127, and fully |
| returning it will transmit a value of 0. In Play mode, the main display |
| will indicate |
| CtrlChg# (Control Change) |
| A control change message will be assigned to the pedal. If you choose |
| CtrlChg#, press the OCTAVE SHIFT/CURSOR [®] key to proceed to |
| “Control Change Select.” (☞p.36 “Assigning a control change”) |
3 | Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “MIDI |
| Channel” (specify the MIDI channel). |
(Red) (Green)
4 | Use the main encoder or the pads to select the MIDI channel on which |
| the MIDI message will be transmitted. The range is |
“About the trigger pad
Setting mode
35