Korg KONTROL49 owner manual VECTOR-Y Vector-Y assignment, SW1/SW2 SW1/SW2 assignment

Operation–Setting mode

5	Use the main encoder or the pads to select the MIDI channel on which
	the assigned MIDI message will be transmitted. The range is 1–16 (ch).
	(☞p.4 “About the trigger pad functions–Input numerical values”)
6	Press the [ENTER] key.
	The setting will be updated, and you will return to Play mode.

If you want to keep the changes you’ve made, save them in Scene mode. If you turn off the power or select a different scene without saving, your changes will be discarded. For details, see “Scene mode–[16] WRITE” (☞p.55).

Using the switches in one-parameter mode

If you choose one-parameter mode, either control changes (CC#) or program changes can be assigned to switches 1 and 2.

1	Hold down the [SETTING] key and press pad [9].
	The [SETTING] key and pad [9] will light; now you can make SW1/

SW2 assignments. The main display indicates “Assignment Select” (select the assignment method).

In “Assignment Select” you can choose either one-parameter assignment mode or two-parameter assignment mode.

[8] VECTOR-Y (Vector-Y assignment)

Here you can assign a MIDI message to the Y-axis of the vector joystick. In the same way as for the X-axis, you can assign a control change (CC#) message to the Y-axis of the vector joystick.

1	Hold down the [SETTING] key and press pad [8].
	Now you can specify the Vector-Y assignment, and the [SETTING] key

and pad [8] will light. The main display indicates “Message Select” (select the MIDI message). The procedure for assigning the Y-axis of the vector joystick is the same as for the X-axis. For details, refer to “Vector-X assignment” (☞p.31)

[9] SW1/SW2 (SW1/SW2 assignment)

Here you can assign MIDI messages to switches 1 and 2, and specify the MIDI transmit channel.

Switches 1 and 2 can be used either in one-parameter mode (Inc/Dec operation) or in two-parameter mode (separate assignments for each switch).

2	Use the main encoder to select the assignment mode for switches 1 and
	2.
	Here we will select INC-DEC.
	INC-DEC (One-parameter mode)
	Assign a single MIDI message to switches 1 and 2.
	SW1/SW2 (Two-parameter mode)
	Assign separate MIDI messages to switch 1 and switch 2.
3	Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “Message
	Select” (select the MIDI message).

(Red) (Green)

4 Use the main encoder to select the type of MIDI message.

NoAssign

No MIDI message will be assigned to switches 1 and 2. If you choose NoAssign, press the [ENTER] key (blinking) to apply the setting. (☞Step 8)

32