LG Electronics LGxxxA1C-B3 Product Specifications, AC Module, Parameter Section Value, VAC 208VAC

6 Product Specifications

6-1 AC Module

DC Input

Parameter	Section		Value
Power	Max.	295 W	300 W	305 W
	Tolerance	3 %	3 %	3 %
Voltage	Open Circuit	39.7 V	39.8 V	40.0 V
	Max Power Point	31.8 V	32.0 V	32.1 V
Current	Short Circuit	9.85 A	9.98 A	10.10 A
	Max Power Point	9.28 A	9.40 A	9.52 A
Efficiency	Relative Reduction		< 2.0 %
	Note : Relative efficiency reduction in respect to irradiance.

Note : Rated electrical characteristics are within 10 percent of above figures.
PV module was measured at STC. (Standard Test Condition: Irradiation 1,000W/m2, Cell temp. 77ºF(25℃),
1.5AM)
			AC Output
Parameter		Section	240VAC		208VAC
		AC Continuous1)	280W(@DC Module 295W) /		285W(@DC Module 300W) /
Power			290W(@DC Module 305W)
		Inverter Rated Continuous	305 W		300W
Voltage		Rated	240 V (211 ~ 264 V)		208 V (187 ~ 229 V)
Current		Rated	1.27 A		1.44 A
		Max Fault Current		77 A
Frequency		Nominal	60 Hz (59.3 ~ 60.5 Hz)
		Extended2)	57.0 Hz ~ 60.5 Hz
	Power Factor			> 0.95
CEC Weighted Efficiency			96.5 %		96.0 %
(California Energy Commission)
Max. Number of AC Modules3)			12 units		11 units

1)AC Continuous = Max Input DC Power x CEC Efficiency.

2)For setting frequency rage, refer to Chapter 4-3. Configuring the Instalation App - Step 5.

3)For details, refer to Chapter 3-10. Connecting AC Module Array to Distribution Panel.

	Protection
Ground Fault Detection and Interrupt (GFDI)	Applied
Fuse (Internal of the Micro Inverter)	2A

CAUTION : FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE.
Over Current Protection Device (OCPD)3)	20A

3)For details, refer to Chapter 3-10. Connecting AC Module Array to Distribution Panel.

31