LG Electronics LGENBOX-01, LGxxxA1C-B3 Fix AC module to the PV rack in the following order

Page 10

Fix AC module to the PV rack in the following order:

Step1. Peel adhesive label attached on the side of PV frame of AC modules and stick on a piece of paper mirroring the array to map for monitoring.

Serial No. K2xxxxxxxxxx

MAC Address : 48:D1:8E:40:00:90

Made in Korea

Step 2. Place AC modules on the PV rack with a minimum gap of 0.236 inch (6mm) between each module. To prevent the risk of slipping during installation, mount AC modules one by one. Connect trunk cables to each mounted AC module. (Refer to Chapter 3-8. Connecting AC Modules)

Step 3. Fixate the PV module to the PV rack on the four mounting holes (marked by points below) with 4 M6 stainless bolts, 4 nuts, 4 spring washers, and 8 flat washers.

(To mount according to the different type of PV racks, refer to the next page under Mounting According to the Different PV Racks)

Connecting the PV Rack and PV Module

Module frame

Bolt

Flat washer

Flat washer

Spring washer

Nut

Support

WARNING

• To prevent the danger of the electric shock, make sure to turn off the circuit breaker prior to installation.

10

Image 10

Contents AC Module System Installation Instructions Table of Contents RevisionsSafety Symbols SafetyImportant Safety Instructions For Micro inverter & Communication Gateway Circuit SymbolsFCC Guidelines For Communication Gateway Indoor use onlyAC Module System IntroductionAdvantages of AC Module System Communication gatewayInspecting the Area of Installation Before InstallationAC Module Inspecting Components of the AC Module Measuring AC Voltage of the UtilityWiring Diagram of AC Module System Product Specification Installing the AC Junction Box and PV RackMounting the AC module Fix AC module to the PV rack in the following order Mounting According to the Type of PV rack Trunk connector removal Connecting AC Modules Trunk CableTrunk connector insertion Trunk cable usage and maintenancePage Checking the Accessories Checking AccessoryCable Usages According to AC Junction Box Locations Grounding Samples for Grounding Male transition cable AC output single phase 240VAC Connect the general AC cables in the following orderAC output three phase 208VAC merge type AC output three phase 208VAC split type Maintenance OperationEnerBoxTM Communication Gateway Checking Components of the Communication GatewayConnecting to the Communication Gateway LED status TroubleshootingConfiguring the Installation App Checking installed AC modules LGElectronics Checking conditions of installed AC modules Setting the grid configurationSetting System Configuration WebsiteAccessories Diagram DetailsParameter Section Value Product SpecificationsAC Module Section 240VAC 208VACDimensions EnerBox Internal Communication with AC moduleDedicated Cables Response to Abnormal ConditionsRange Clearing Time s Contact WarrantyTransporting and Storage Disclaimer of Liability

Related manuals

Manual 24 pages 22.32 Kb