Meco Bonza Deluxe Series manual Before Using Your LP GAS Grill, Selecting a Location, Precautions

Page 23

·Never connect or disconnect LP gas cylinder or fittings while grill is in use or is hot.

·When the LP gas cylinder is connected, the grill must be kept outside in a well-ventilated space. Turn off all of the grill control knobs and the LP cylinder valve when grill is not in use.

·Move gas hose as far away as possible from hot surfaces.

How to Connect your LP gas cylinder (See STEP 12 of Assembly Instructions for diagram)

1)Make sure all of the control panel knobs are turned to the “off” position and verify that the LP gas cylinder valve is closed by turning the handle on the LP gas cylinder valve clockwise until it stops.

2)Remove the protective cap from the LP cylinder gas nozzle.

3)Hold regulator in a straight line with LP cylinder gas nozzle so the connection does not cross thread.

4)Insert nipple into the LP cylinder nozzle opening.

5)Hand tighten coupling nut in a clockwise direction. Do not use tools.

6)Perform a Leak Test. (See STEP 13 of Assembly Instructions for Leak Test Instructions)

How to Disconnect your LP gas cylinder

1)Turn all control knobs to the “off” position and turn the handle on the LP gas cylinder clockwise until it stops.

2)Turn coupling nut on regulator in a counter-clockwise direction until regulator is released from threaded LP cylinder gas nozzle.

3)Place the protective cap over LP cylinder gas nozzle.

BEFORE USING YOUR

LP GAS GRILL

Selecting a Location

·Do not use an LP gas grill indoors, on recreational vehicles, or on a boat.

·This LP gas grill is for outdoor use only and should be placed on firm, level surface. The grill should be setup in an open area with good ventilation, away from high traffic areas and combustible materials.

·Combustible or flammable materials should never be used or stored within 36 inches of the back or sides of your LP gas grill.

·Locate your LP gas grill at least 10 feet away from your house or any building. Do not use the grill in a garage, breezeway, carport, porch, or under a surface that can catch fire.

·When moving or lifting your Aussie LP gas grill, its recommended that you grasp the cross supports under the side tables. Do not lift the grill with only the individual side table slats.

·When moving your gas grill, you should push the grill in front of you with the large wheels in the front.

Precautions

· Carefully read the Important Safeguards

section

of this manual (pages 2 thru 4). Make

sure you

follow and understand all instructions

and

 

warnings. If you have any questions

regarding

these pages, call 1-800-251-7558 and

· This installation must conform with local codes or, in the absence of local codes, with either the

National

Fuel Gas Code, ANSI Z223.1, or CAN/CGA-

B149.2,

Propane Installation Code.

·If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be

electrically grounded in accordance with local

codes or, in the absence of local codes, with the

National

Electrical Codes, ANSI/NFPA 70, or the

Canadian

Electrical Code, CSA C22.1.

· If any electric appliance or rotisserie is used with

the

LP gas grill, do not allow cords to touch or be near

hot

 

 

surfaces. Electric cords should be placed away from walkways to avoid a tripping hazard.

· Grill storage cover must be removed and placed

at least 36 inches from the LP gas grill while in use.

The

grill cover is made of a flammable material. The

grill

must be completely cooled before putting the

cover back on the grill.

· Never store a spare or disconnected LP gas

cylinder

under or near this LP gas grill.

· Inspect the hose and regulator assembly before

each

use. If the hose is cut or damaged or shows

signs of

excessive abrasion or wear, do not use the

LP gas

grill. Contact the manufacturer, as the hose

must be

replaced with an assembly specified by the

manufacturer prior to the further use of the LP

gas

grill.

· Use only the hose and regulator assembly that

is

supplied with your LP gas grill.

· Use of this LP gas grill other than for the

intended

use, or alteration of the LP gas grill in any

way may

not be safe and will void any warranty.

·LP gas is not natural gas. The conversion or attempted use of natural gas in an LP unit is dangerous and will void your warranty.

·Never use an LP gas cylinder if it shows signs of: dents, gouges, bulges, fire damage,

corrosion,

leak age, excessive rust, or other forms of

visual

external damage; it may be hazardous and

should be

checked by a Liquefied Petroleum supplier.

Do not

use an LP cylinder with a damaged valve.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents AussieTM by For Your SafetyImportant Safeguards Gas tion of clogged Continuing use. See Before Using Your LP GasDo not attempt to correct the problem yourself GrillMeco Corporation Bonza Deluxe PART/DESCRIPTIONBonza Bonza Bonza Deluxe PART/ DescriptionDeluxe PART/ Description Bonza PART# QTYPART/ Description PART# QTY Bonza Item 1 or 3 Side Table X 1 3/8 Bolt 8pcs X 1 Bolt 8 pcs Wheel LEG/ Side Table Assembly ToolsX 1 3/8 Fixed LEG/SIDE Table AssemblyTools Item 9 8 pcs Item 8 8 pcsPcs LEG Brace Assembly ToolsX 1 Bolt Wood LEG 1/4 x 1 3/8 Bolt Metal LEG Bottom SHELF/LEG & Caster Assembly ToolsX 1 Bolt Wood LEG X 2 Bolt WOO X 1 3/8 Bolt MetalX 1/2 Bolt WHEEL/CYLINDER Bracket Assembly ToolsItem 22, 23 Item 26 4 pcsAssembly Next Grill BODY/CART ASSEMBLY- Bonza & Bonza Deluxe ModelsRegulator Grill BODY/CART ASSEMBLY- Bonza ModelsOr 4 PCS Install Burner ToolsAttach Decorative Privacy Panel to Cart ALL Models NextFIG. F FIG. E#8 X 1/2 Screw 2pcs Install Bottom Body PANEL/GREASE TRAY- ALL ModelsAttach Handle and Heat Indicator to Hood Bonza Models Tools FIG. H Attach LP Cylinder to Grill ALL ModelsHow to perform a leak test Leak Testing to be Performed in a WELL-VENTILATED AreaLP Gas Cylinder Connecting/ Disconnecting LP Gas Cylinder to Grill· Always check for gas leaks when you GAS, CYLINDER, Hose Regulator InformationSelecting a Location Before Using Your LP GAS GrillPrecautions Operating the LP GAS Grill LeakTestingConfirm each burner is lit before lighting another burner Lighting the Grill Using the Integra Spark Ignition SystemPreparation Before Cooking Dripping onto the cart and/or a grease fireWood Chunks placed along left or right side of grill Cooking Mode LP GAS with Wood Chunks for FlavorCooking Mode Charcoal only Open hood How to manually light your LP gas grillManual Lighting of the Grill Roasting Hood Cooking Care and MaintenanceCheck Your Flame End of Cooking Session Grill CookingPorcelain coated Cooking Surfaces Hood Burner MaintenanceHow to clean porcelain coated cast iron burners Bottom Panel/ Grease Tray Cleaning the Grill BodyFlavor Activators Caring for the Wood Cart Cleaning instructions for Charcoal and Wood chunk ashPreventive Maintenance Low flame or low heat Using the igniterUsing a match Burners will not lightHumming or Flames blow outFlare up Persistent grease fireImportant Notice Limited Warranty
Top Page Image Contents