Meco Bonza Series Check Your Flame End of Cooking Session, Grill Cooking, Roasting Hood Cooking

Page 28

Check Your Flame

End of Cooking Session

Your burners have been preset by the manufacturer for optimal flame performance. A blue flame, possibly with a small yellow tip, is the result of the optimal air and LP gas mixture. (See diagram below)

Yellow Tip

Primarily Blue

Flame

The flame should be checked before the initial cooking ses- sion and periodically throughout the grilling season, espe- cially after storing the grill over a long period of time. If the flame is significantly yellow in color, then you are not getting the appropriate amount of LP gas in the air /LP gas mixture. This could be a result of a blocked burner from grease drip- pings or from insects building a nest inside the burner or burner opening. You should follow the Burner Maintenance section of this manual for cleaning the burners.

Grill Cooking

The cast iron burners heat up the Flavor Activators under- neath the cooking grid, which in turn heats the food on the grill. The natural food juices produced during cooking fall onto the hot Flavor Activators below and vaporize. The sub- sequent rising smoke bastes the food, as it travels upwards, giving it that unique barbecued flavor.

Roasting Hood Cooking

The Grill is equipped with a roasting hood giving the option of cooking with hood closed to form an ‘oven’ for roasting food, such as roasts of meat, whole chickens, etc. When the hood is closed, a large amount of heat is trapped inside the grill. Thus, it is IMPORTANT to make sure that all the burners are turned to the low position to prevent burning of the food. Burners should be turned off after preburn when cooking with charcoal. Avoid lifting the hood unnecessar- ily as heat is lost every time the hood is opened. Use the temperature gauge to check the approximate temperature inside the grill.

·Never leave your LP gas grill unattended during use or cleaning.

After each cooking session, close the hood and turn the grill burners to the “high” position and burn for five minutes. This procedure will burn off cooking residue, thus making cleaning easier.

Turn off Your LP Gas Grill

·The grill must be completely cooled before putting the Grill Storage Cover back on the grill.

How to turn off your LP gas grill

1) When you have finished using your grill, turn the grill Control Knobs clockwise to the “Off” position.

2)Turn off the gas at the LP cylinder valve by turning the handle clockwise completely until it stops.

3)Wait until the grill is cool before closing the grill’s hood.

4)After the LP gas grill has cooled, put the Grill Cover on the grill.

WARNING! Never store an LP gas cylinder indoors (empty or filled). If storing the gas grill indoors, dis- connect LP gas cylinder and store it outdoors out of

reach of children.

CARE AND MAINTENANCE

·Always turn off the LP gas cylinder, at the LP cylinder valve, when not in use. Allow the grill to cool before handling parts or cleaning.

·Do not move an LP gas grill when in use or hot.

·Never touch hot surfaces. Use heat

resistant

gloves, long-handled tongs, or cooking

mitts at all

times since grill will become very hot.

·Do not wear loose clothing (for example: hanging shirt tails, clothing with frills, etc.) around a LP gas grill while in use or hot.

·Never lean your body over the LP gas grill when lighting it or while it is in use or hot.

·Never douse the grill with water when its surfaces are hot because it may cause grease to splatter or

the porcelain cooking grids and hood to break.

·Empty charcoal and wood chunk ashes after each use.

28

Image 28
Contents For Your Safety AussieTM byImportant Safeguards Continuing use. See Before Using Your LP Gas Do not attempt to correct the problem yourselfGrill Gas tion of cloggedMeco Corporation Bonza PART/DESCRIPTIONBonza Deluxe PART/ Description Bonza Bonza DeluxePART/ Description Bonza PART# QTY DeluxePART/ Description PART# QTY Bonza Wheel LEG/ Side Table Assembly Tools Item 1 or 3 Side Table X 1 3/8 Bolt 8pcs X 1 Bolt 8 pcsFixed LEG/SIDE Table Assembly ToolsItem 9 8 pcs Item 8 8 pcs X 1 3/8LEG Brace Assembly Tools PcsBottom SHELF/LEG & Caster Assembly Tools X 1 Bolt Wood LEG X 2 Bolt WOOX 1 3/8 Bolt Metal X 1 Bolt Wood LEG 1/4 x 1 3/8 Bolt Metal LEGWHEEL/CYLINDER Bracket Assembly Tools Item 22, 23Item 26 4 pcs X 1/2 BoltGrill BODY/CART ASSEMBLY- Bonza & Bonza Deluxe Models Assembly NextGrill BODY/CART ASSEMBLY- Bonza Models RegulatorInstall Burner Tools Attach Decorative Privacy Panel to Cart ALL ModelsNext Or 4 PCSFIG. E FIG. FInstall Bottom Body PANEL/GREASE TRAY- ALL Models #8 X 1/2 Screw 2pcsAttach Handle and Heat Indicator to Hood Bonza Models Tools Attach LP Cylinder to Grill ALL Models FIG. HLeak Testing to be Performed in a WELL-VENTILATED Area How to perform a leak testConnecting/ Disconnecting LP Gas Cylinder to Grill · Always check for gas leaks when youGAS, CYLINDER, Hose Regulator Information LP Gas CylinderPrecautions Before Using Your LP GAS GrillSelecting a Location LeakTesting Operating the LP GAS GrillLighting the Grill Using the Integra Spark Ignition System Preparation Before CookingDripping onto the cart and/or a grease fire Confirm each burner is lit before lighting another burnerCooking Mode Charcoal only Cooking Mode LP GAS with Wood Chunks for FlavorWood Chunks placed along left or right side of grill Manual Lighting of the Grill How to manually light your LP gas grillOpen hood Care and Maintenance Check Your Flame End of Cooking SessionGrill Cooking Roasting Hood CookingHow to clean porcelain coated cast iron burners Burner MaintenancePorcelain coated Cooking Surfaces Hood Flavor Activators Cleaning the Grill BodyBottom Panel/ Grease Tray Preventive Maintenance Cleaning instructions for Charcoal and Wood chunk ashCaring for the Wood Cart Using the igniter Using a matchBurners will not light Low flame or low heatFlames blow out Flare upPersistent grease fire Humming orImportant Notice Limited Warranty