Meco Bonza Deluxe Series Manual Lighting of the Grill, How to manually light your LP gas grill

Page 27

Manual Lighting of the Grill

·Open Hood before lighting the grill to prevent an explosion from gas build-up.

· Always inspect the gas hose and regulator as- sembly before each use. If the hose is cut, dam-

aged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.

4)Locate the control knob that corresponds to the match lighting hole that you are using. Push in and turn the control knob counter-clockwise until a click is heard.

WARNING: If the burner fails to ignite after following the above procedure, turn all the knobs

to

the off position and close the valve on the LP cylinder.

Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails

to light, see the Troubleshooting page.

5)Light the remaining burners from left to right by turn- ing the control knob counter-clockwise. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before lighting another burner.

How to manually light your LP gas grill

1)Open Hood.

2)Important: The LP gas cylinder valve must

be

opened first before turning the control knobs on

the

grill. Turn the handle on the LP cylinder valve

counter- clockwise until it stops.

3) Insert a lit match through one of the match-

lighting

holes underneath the front control panel on

the grill.

(See figure below).

1. Open hood

6)After ignition, burners should be burned at the high position for 3-5 minutes in order to preheat the grill. This process should be done before every cooking session.

The hood should be closed during preheating when cooking with gas. The hood should be open during preburn when using charcoal or wood chunks.

WARNING: If a burner goes out during the cooking cycle, turn all knobs to the off position and close the valve on the LP cylinder. Open hood and wait

2.Turn LP cylinder handle counter-clockwise - “ON”

3.Match lighting hole in left side of grill body - Insert a lit match through the match lighting hole.

4.Push in and turn control

knob counter-clockwise to the “High” position. (Note a click may be heard)

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents AussieTM by For Your SafetyImportant Safeguards Gas tion of clogged Continuing use. See Before Using Your LP GasDo not attempt to correct the problem yourself GrillMeco Corporation PART/DESCRIPTION BonzaBonza Deluxe Bonza Bonza Deluxe PART/ DescriptionDeluxe PART/ Description Bonza PART# QTYPART/ Description PART# QTY Bonza Item 1 or 3 Side Table X 1 3/8 Bolt 8pcs X 1 Bolt 8 pcs Wheel LEG/ Side Table Assembly ToolsX 1 3/8 Fixed LEG/SIDE Table AssemblyTools Item 9 8 pcs Item 8 8 pcsPcs LEG Brace Assembly ToolsX 1 Bolt Wood LEG 1/4 x 1 3/8 Bolt Metal LEG Bottom SHELF/LEG & Caster Assembly ToolsX 1 Bolt Wood LEG X 2 Bolt WOO X 1 3/8 Bolt MetalX 1/2 Bolt WHEEL/CYLINDER Bracket Assembly ToolsItem 22, 23 Item 26 4 pcsAssembly Next Grill BODY/CART ASSEMBLY- Bonza & Bonza Deluxe ModelsRegulator Grill BODY/CART ASSEMBLY- Bonza ModelsOr 4 PCS Install Burner ToolsAttach Decorative Privacy Panel to Cart ALL Models NextFIG. F FIG. E#8 X 1/2 Screw 2pcs Install Bottom Body PANEL/GREASE TRAY- ALL ModelsAttach Handle and Heat Indicator to Hood Bonza Models Tools FIG. H Attach LP Cylinder to Grill ALL ModelsHow to perform a leak test Leak Testing to be Performed in a WELL-VENTILATED AreaLP Gas Cylinder Connecting/ Disconnecting LP Gas Cylinder to Grill· Always check for gas leaks when you GAS, CYLINDER, Hose Regulator InformationBefore Using Your LP GAS Grill PrecautionsSelecting a Location Operating the LP GAS Grill LeakTestingConfirm each burner is lit before lighting another burner Lighting the Grill Using the Integra Spark Ignition SystemPreparation Before Cooking Dripping onto the cart and/or a grease fireCooking Mode LP GAS with Wood Chunks for Flavor Cooking Mode Charcoal onlyWood Chunks placed along left or right side of grill How to manually light your LP gas grill Manual Lighting of the GrillOpen hood Roasting Hood Cooking Care and MaintenanceCheck Your Flame End of Cooking Session Grill CookingBurner Maintenance How to clean porcelain coated cast iron burnersPorcelain coated Cooking Surfaces Hood Cleaning the Grill Body Flavor ActivatorsBottom Panel/ Grease Tray Cleaning instructions for Charcoal and Wood chunk ash Preventive MaintenanceCaring for the Wood Cart Low flame or low heat Using the igniterUsing a match Burners will not lightHumming or Flames blow outFlare up Persistent grease fireImportant Notice Limited Warranty
Top Page Image Contents