STEP 4-BOTTOM SHELF/LEG & CASTER ASSEMBLY
TOOLS:
(ITEM 8) 4 pcs 1/4” x 1” BOLT
(ITEM 21) 1/4” X 2” BOLT 4 pcs
(ITEM 9) 8 pcs | (ITEM 16 OR 17) AXLE |
| |
1/4” X 1 3/8” BOLT |
|
(DELUXE MODELS) | |
| (ITEM 15) BOTTOM SHELF |
(ITEM 18, 19, 20) CASTER ASSEMBLY
•Place Leg/Side Table assemblies opposite each other as shown with the velcro patches on same side. •Place Bottom Shelf inside of Wheel Leg assembly and align large axle holes. Insert Axle through axle holes in both sides of legs and shelf. The Axle will support this end of Bottom Shelf while securing Fixed Leg assembly.
•Position Caster Assembly with caster wheels up and side of bracket against Bottom Shelf. Align the Caster Bracket, Bottom Shelf, and Fixed Leg holes and fasten using 1/4” X 2” Bolts. Attach Wheel Legs to Bottom Shelf using 1/4” x 1” Bolts. Metal Tubing Legs will use 1/4” x 1 3/8” Bolts. Tighten
Wheel Leg bolts before proceeding.
•For Bonza Deluxe, align the Bottom Shelf and Leg holes and fasten using 1/4” x 1 3/8” bolts. At- 
tach Bonza Deluxe Wheel Legs the same way. Thread casters into end of leg.
•Bonza Deluxe - Important Note: When assembling Bottom Shelf on metal legs, the Axle hole in the 
Bottom Shelf is not used(See Illustration below).
DELUXE
METAL LEG
AXLE
HOLE
WHEEL LEG
ASSEMBLY
1/4” x 1” BOLT - WOOD LEG | 1/4” x 2” BOLT - WOO | |||
1/4” | X 1 | 3/8” BOLT - METAL | ||
1/4” x 1 3/8” BOLT - METAL | ||||
|
|
| ||
| CASTER |
|
| |
BOTTOM SHELF | ASSEMBLY | DELUXE | ||
|
| |||
|
| CASTER | ||
|
|
| ||
AXLE |
|
|
| |
VELCRO |
|
|
| |
PATCHES |
|
|
| |
ON THIS |
|
| FIXED LEG | |
SIDE |
|
| ASSEMBLY | |
1/4” x 1” BOLT - WOOD LEG 1/4” x 1 3/8” BOLT - METAL LEG
12