The support legs must be used for the Largo barbecue only, or for ingredients and utensils reserved for barbecue use.
In the horizontal position, the trays will support a maximum weight of 3 kg.
Plugging in and preheating
Place the appliance on its support legs or on a flat, stable,
Avoid using it on a soft base.
Never place the appliance directly on a fragile support (glass table, tablecloth, varnished furniture, etc.).
To avoid overheating of the appliance, never place it in a corner or against a wall.
Unwind the cord completely.
Check that the electrical installation is compatible with the power and voltage indicated on the bottom of the appliance.
Only plug the appliance into earthed sockets.
Supply the appliance through a residual current device (RCD) having a tripping current not exceeding 30 mA.
If an extension cord is used:
-this must be earthed and rated accordingly;
-take all precautions necessary to ensure that no one will get tangled in it.
The supply cord should be regularly examined for signs of damage and the appliance is not to be used if the cord is damaged.
If the power supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Open the protective cover (1).
The heating element terminals of the appliance must always be dried thoroughly before using the appliance.
Clip the locking strut (14) of the cover (1) into place.
Insert the control unit (4) fully into the appliance and then plug into the mains: the pilot lamp lights up.
The control unit (4) cannot be inserted when the cover is closed.
Do not use any other control unit (4) other than the one supplied with your appliance.