Cal Flame LTR50001038 manual Installing Grills in Barbecue Islands, Installing the Rotisserie

Page 11

Installing Grills in Barbecue Islands

You will need a second person to help you to avoid damaging the grill, the transformer, or your barbecue island..

Before installing a grill or side burner in any island or cut out, make sure that the opening is not bigger than the outside frame of the grill unit. The grill should rest on the lip of the frame. For drop-in accessories, adequate cross ventilation must be designed into enclosure to ensure the drop-in grill or side burner does not become overheated.

Pay careful attention to the location of gas lines. Gas lines should be routed away from sources of heat and should make as few bends as possible.

Check to see if gas line connections will be accessible when grill is installed.

•If gas line connections are not easily accessible when the grill is installed, support the grill above counter level and attach the gas lines to the grill. When the gas connections are made, slide the grill into the cut out.

•If gas line connections are accessible when the grill is installed, slide the grill into the cut out and then attach the gas lines.

Be very careful not to kink gas lines when lowering the grill or side burner into the cut out.

Keep your fingers away from where the grill will be supported on counter. Your fingers could become trapped and serious injury could occur.

Check to make sure the grill is level and is supported around the entire outside edge. If the grill is not level or is unstable, use non-combustible shims under the outside lip to stabilize it.

Perform the leak test procedure as described earlier in this manual.

Barbecue Grills

Installing the Rotisserie

Attach the two brackets to the sides of the grill, one on each side, using two screws as shown below.

Slide the rotis motor on one of the brackets as shown below. The rotis motor will work on either side of the grill.

Remove the metal cap protecting the outlet that provides power for the rotis motor. Plug in the motor cord and screw on the retainer nut to keep the plug in place.

9 Installation

LTR50001038, Rev. C

www.calflamebbq.com

Page 10 Page 12
Image 11
Page 10 Page 12
Contents LTR50001038, Rev. C 12/26/11 Read all instructions before you Operate your grill Set-Up Safety InstructionsPlacement and Location InstructionsStorage Maintenance and RepairPrecautions Regarding Children This section Built-in ConstructionLocation of grill enclosure Construction materialsModel Description Width Depth Height Built-in DimensionsModel Description Width Depth Built-in ConstructionEnclosure Ventilation Electrical Supply Requirements Plumbing for Side BurnersInstalling the Transformer InstallationInstalling the Rotisserie Installing Grills in Barbecue IslandsGas Requirements and Connection Leak Testing ProcedureGas Connection LP Gas Hook Up Cylinder SpecificationLP Gas Tank RequirementsConnection Natural GasRequirements Basic Grill Operation Using Your GrillYour Grill Grill Controls Using GrillYourManually Lighting the Burners UsingYour GrillLighting the Burners Electronically Lighting the BurnersConvection Fan Heat Distribution on the Cooking GratesLoading food on the rotisserie rod Cooking with the RotisseriePizza Brick Tray Optional Grill AccessoriesOptional Sear Zone Infrared BurnerCharcoal Tray PlacementUsing the Charcoal Tray Removal and Clean-upPull-Out Cutting Board Deep Fryer Helper SetGriddle Tray Cleaning Products and Materials Cleaning and MaintenanceMaintenance Stainless Steel Care and CleaningRust removal with Instant Rust Out Cleaning the Interior of Your GrillRust Removal BurnersDrip Pan Steam Cleaning Your GrillCovering Your Grill Cooking GratesRemove the burners Seasonal CleaningClean the burners Replace the components Clean the grill interiorClean the components Replace the burnersSnap-in Light Lens Light Bulb ReplacementLight Lens with Screw Clip Appendix TroubleshootingProblem Flashback Problem Yellow FlameProblem Plugged orifice Problem Misalignment of Igniter on BurnerWith your grill Switching the regulatorConverting from LP to NG Behind the grillReplace the main burner orifices Changing the burner orificesMark the rating plate AppendixInstalling Sear Zone Burners Wiring Diagram Replacement Parts Part Grill Size Ordering replacement partsWarranty Limitations Limited WarrantyExtent of Warranty Warranty PerformanceLegal Remedies Customer ServiceDisclaimers Locating the product serial number Don’t forget to register your new product at
Top Page Image Contents