Cal Flame LTR50001038 manual Problem Yellow Flame, Problem Plugged orifice, Problem Flashback

Page 30

28 Appendix

Problem: Yellow Flame

Solution: Once the entire burner is operating, check the flame color to be sure that it is mostly blue. Some yellow at the tips may be present due to impurities in the fuel. If the flame is golden or yellow in color, the reason could be seasoning salts, oil film, or other foreign matter on the burner.

Problem: Plugged orifice

Solution: Unplug the orifice as follows:

•Remove cooking grills, flame tamer and grease tray.

•Remove burners from the bottom of the firebox by pulling the locking pin from beneath the burner peg using a standard screwdriver or needle nose pliers.

•Carefully lift each burner up and away from the gas orifice.

•Remove the orifice from the control valve.

•Gently clear any obstruction with a fine wire.

•Reinstall the orifice, reinstall the burners over the orifices, and seat each burner peg into position hole at the bottom ledge of the firebox.

•Replace cooking components and grease collectors.

If an obstruction is suspected in the control valve, contact your local Cal Flame dealer for assistance.

Problem: Misalignment of Igniter on Burner

Solution: • Check for proper position of the electrode tip, which should be pointing forward towards the front of the burner and free of grease to allow proper sparking.

•The ignition wire should be connected firmly to the valve ignition device and electrode. Replace the ignition wire if it is frayed or cracked.

•With the gas supply closed and all control knobs set to the off position, check each position igniter individually for the presence of a spark at the electrode. Push each knob in fully and rotate it about 1/4 turn to the left (counter-clockwise) until you hear a loud click. The trigger hitting the strike block should produce a blue spark at the electrode tip. Return control knob to the off position before checking the next igniter.

•While the grill is still hot, wait for a minimum of five minutes before commencing re- ignition. (This allows accumulated gas fumes to clear.) If all checks / corrections have been made and the gas grill still fails to operate properly, contact your local Cal Flame dealer.

Problem: Flashback

Solution: When fire occurs in and around the burner tubes, immediately turn off gas at its source and turn the control knobs clockwise to the ‘OFF’ position. Wait until the grill has cooled off and then clean the burner tubes and burners as described on page of this manual.

Barbecue Grills

www.calflamebbq.com

LTR50001038, Rev. C

Page 29 Page 31
Image 30
Page 29 Page 31
Contents LTR50001038, Rev. C 12/26/11 Read all instructions before you Operate your grill Instructions Safety InstructionsPlacement and Location Set-UpMaintenance and Repair Precautions Regarding ChildrenStorage Construction materials Built-in ConstructionLocation of grill enclosure This sectionBuilt-in Dimensions Model Description Width Depth HeightBuilt-in Construction Model Description Width DepthEnclosure Ventilation Plumbing for Side Burners Electrical Supply RequirementsInstallation Installing the TransformerInstalling Grills in Barbecue Islands Installing the RotisserieLeak Testing Procedure Gas ConnectionGas Requirements and Connection Tank Requirements Cylinder SpecificationLP Gas LP Gas Hook UpNatural Gas RequirementsConnection Using Your Grill Your GrillBasic Grill Operation Using GrillYour Grill ControlsElectronically Lighting the Burners UsingYour GrillLighting the Burners Manually Lighting the BurnersHeat Distribution on the Cooking Grates Convection FanCooking with the Rotisserie Loading food on the rotisserie rodSear Zone Infrared Burner Optional Grill AccessoriesOptional Pizza Brick TrayRemoval and Clean-up PlacementUsing the Charcoal Tray Charcoal TrayDeep Fryer Helper Set Griddle TrayPull-Out Cutting Board Stainless Steel Care and Cleaning Cleaning and MaintenanceMaintenance Cleaning Products and MaterialsBurners Cleaning the Interior of Your GrillRust Removal Rust removal with Instant Rust OutCooking Grates Steam Cleaning Your GrillCovering Your Grill Drip PanSeasonal Cleaning Clean the burnersRemove the burners Replace the burners Clean the grill interiorClean the components Replace the componentsLight Bulb Replacement Light Lens with Screw ClipSnap-in Light Lens Troubleshooting AppendixProblem Misalignment of Igniter on Burner Problem Yellow FlameProblem Plugged orifice Problem FlashbackBehind the grill Switching the regulatorConverting from LP to NG With your grillChanging the burner orifices Replace the main burner orificesAppendix Mark the rating plateInstalling Sear Zone Burners Wiring Diagram Replacement Parts Ordering replacement parts Part Grill SizeWarranty Performance Limited WarrantyExtent of Warranty Warranty LimitationsCustomer Service DisclaimersLegal Remedies Don’t forget to register your new product at Locating the product serial number
Top Page Image Contents