A&D Ambulatory Blood Pressure Monitor instruction manual Environment specifications

Page 13

1 -5V ~ -15V

Communications/Data Output

Interface Specifications

Connected to a computer, you can output the data and enter parameters. Connected to a printer, you can print the data. EIA RS-232C, Asynchronous, bi-directional, half duplex

Baud rate	9600 bps
Data bits	8 bits
Stop bits	2 bits
X parameter	Used (for computer)
	Not used (for printer)
Parity	None
Code	ASCII	RS-232C

	LSB	1	2		3	4	5	6	MSB
	0	1	2		3	4	5	6	7	0	+5V ~ +15V
Start bit				Data bits					Stop bits	0	+5V ~ +15V
Start bit				Data bits					Stop bits

Environment specifications

Operating environment		+10° C ~ +40° C (+50° F ~ +104° F), Less than 85%RH *
Operating environment		+10° C ~ +40° C (+50° F ~ +104° F), Less than 85%RH *
Transport and Storage		-20°C ~ +55° C (-4°F ~ +131° F), Less than 95%RH *
* Non Condensing
Physical specifications
Dimensions		72(W) x 100(D) x 27(H) mm
		2.8(W) x 3.9(D) x 1.0(H) in.

Weight		Approx. 215 g (0.47lb) excluding cuff

72mm

					SYS/INTERVAL
					DIA
					PULSE/TIME					A I R
START	AUTO									A I R
STOP	ON/OFF
	0	1	2	3	4	5	6	7	8	9
	0
	1
	2

27mm

100mm

Specifications

Page 11

Functions and Specifications

Image 13

Contents TM-2430 Page Contents Compliance Before useDefinitions Precautions for Use Storage Periodic maintenanceBefore use During useProduct overview WelcomeWelcome and Introduction Packing List and Component NamesAir socket Display Symbols Features Specifications Functions and Specifications Stopping a measurement Automatic measurementConcealing the measurement value PressurizationPerformance specifications Environment specifications Replacing Batteries Activating the recorderSteps for replacing the batteries When recorder is Condition Actions Turned on Conditions When Recorder Switched OnParameters for the Display and Clock Display & keySteps for setting the display and clock Selection for the Automatic Measurement Steps for selecting a modeMode Set up procedure Mode III SettingsAs the start time of the third block Steps for automatic measurementFrom previous Steps for reset Resetting the RecorderDeleting Old Data Steps for deleting old dataPreparing the patient Stopping or canceling an automatic measurementPatient instructions Manual measurementAttaching the cuff and recorder Use of the cuff coverSteps for attaching the cuff and recorder Range, you need a proper cuff Using the Shoulder Band Using the BeltPreparation of the Carrying Case Automatic Measurement OperationManual Measurement To stop a Current MeasurementData Transfer Specifications for an adaptable printerData Transmission to a Printer Print sample Steps for data transmissionData Transmission to a Computer Using Analysis Soft Analysis Software and Communication Cables Options and accessoriesCuff sleeves Cuffs and Other AccessoriesCuff cover OthersChecking Accuracy MaintenanceRequired equipment Steps for checking accuracyProblem solving Cleaning the cuff and recorderPeriodical inspection Error code updates without announcement Error codesMaintenance Error Code Memo

Communications/Data Output

Interface Specifications

Environment specifications

Physical specifications