A&D Ambulatory Blood Pressure Monitor instruction manual Steps for data transmission, Print sample

Page 28

	Steps for data transmission

Step	1	Enter the parameters into the printer so that the data
		can be transmitted.
		Connect the cable to both the recorder and printer.
Step	2	Connect the cable to both the recorder and printer.
		Then the recorder displays	. Refer to "Analy-
		Then the recorder displays	. Refer to "Analy-
		sis Software and Communication Cable" about the
		cable.
		Set the printer to "ON LINE".
Step	3	Set the printer to "ON LINE".

Setup for printer

Connection

On line (Ready)

Start Stop

Step	4	Press the	START STOP	key. Then	is displayed
		and the data is transmitted.
		and the data is transmitted.
		When the transmission is finished,			is dis-
Step	5	When the transmission is finished,			is dis-
		played.
		played.
		Remove the cable at once. The clock is displayed.
Step 6		Remove the cable at once. The clock is displayed.

Remove the cable

Print sample
=====================			ABPM DATA TABLE		======================
No.	Date	Time SYS(mmHg) DIA(mmHg)				PUL(bpm) ERR
--------------------------------------------------------------
1	`97/ 5/17	7:43		103	65	55	-
2	`97/ 5/17	8:00		119	79	65	-
3	`97/ 5/17	8:30		125	88	132	-
4	`97/ 5/17	9:00		122	84	116	-
5	`97/ 5/17	9:30		115	87	63	-
6	`97/ 5/17 10:00			118	76	61	-
7	`97/ 5/17 10:30			-	-	-	08
8	`97/ 5/17 10:35			116	82	68	-
9	`97/ 5/17 11:00			114	75	62	-
10	`97/ 5/17 11:30			122	81	94	-
11	`97/ 5/17 12:00			123	86	88	-
12	`97/=5/17 12:30			112	76	65	-

Data Transfer

Page 26

Data transmission to a printer

Image 28

Contents TM-2430 Page Contents Compliance Before useDefinitions Precautions for Use Periodic maintenance StorageBefore use During useWelcome Product overviewWelcome and Introduction Packing List and Component NamesAir socket Symbols DisplayFeatures SpecificationsFunctions and Specifications Automatic measurement Stopping a measurementConcealing the measurement value PressurizationPerformance specifications Environment specifications Replacing Batteries Activating the recorderSteps for replacing the batteries Conditions When Recorder Switched On When recorder is Condition Actions Turned onParameters for the Display and Clock Display & keySteps for setting the display and clock Selection for the Automatic Measurement Steps for selecting a modeMode Mode III Settings Set up procedureSteps for automatic measurement As the start time of the third blockFrom previous Resetting the Recorder Steps for resetDeleting Old Data Steps for deleting old dataStopping or canceling an automatic measurement Preparing the patientPatient instructions Manual measurementAttaching the cuff and recorder Use of the cuff coverSteps for attaching the cuff and recorder Range, you need a proper cuff Using the Shoulder Band Using the Belt Preparation of the Carrying Case Operation Automatic MeasurementManual Measurement To stop a Current MeasurementData Transfer Specifications for an adaptable printerData Transmission to a Printer Steps for data transmission Print sampleData Transmission to a Computer Using Analysis Soft Options and accessories Analysis Software and Communication CablesCuffs and Other Accessories Cuff sleevesCuff cover OthersMaintenance Checking AccuracyRequired equipment Steps for checking accuracyProblem solving Cleaning the cuff and recorderPeriodical inspection Error codes Error code updates without announcementMaintenance Error Code Memo