Mode III Settings
Set up procedure
Before you enter into mode III, read the procedure below. Also, refer to the example on the next page for the setting procedure.
❏Each blocks starting time must match the previous blocks finish time.
❏The end of block 6 automatically equalizes to start time of the block 1.
❏If you enter the block 1 start time in any other block, these parameters are saved and this sequence is finished.
❏When selecting 120 minutes for the current frequency, you must adjust the start time of the next block so that the current block fits a multiple of 120 minutes. If you do not fit to the next start time, an error code is displayed.
❏The recorder displays as 60 minutes and as 120 minutes.
❏When you enter the sequence of mode III settings, the recorder initializes each start time to the start time of block 1 and each frequency to
Display & key
Sequence number
Parameter
START
STOP
Sign of setting parameters for automatic measuremnt
Selecting a parameter
AUTO
ON/OFF
Selecting a sequence number
Items
Sequence | Parameters (monitor) | Meaning | Initial value |
number |
|
|
|
01 | 0 ~ 23 o'clock | Start time of first block |
|
02 | Frequency of first block |
| |
03 | 0 ~ 23 o'clock | Start time of second block |
|
04 | Frequencyofsecondblock |
| |
05 | 0 ~ 23 o'clock | Start time of third block |
|
06 | Frequency of third block |
| |
07 | 0 ~ 23 o'clock | Start time of fourth block |
|
08 | Frequency of fourth block |
| |
09 | 0 ~ 23 o'clock | Start time of fifth block |
|
10 | Frequency of fifth block |
| |
11 | 0 ~ 23 o'clock | Start time of sixth block |
|
12 | Frequency of sixth block |
| |
13 | 0 ~ 23 o'clock | End of sixth block |
|
The
Selection for the Automatic Measurement | Page 16 | Initializing the recorder |