Invacare PHW93, PH904A manual Operating Information

Page 15

SECTION 1—GENERAL GUIDELINES

To maintain the stability of the wheelchair when moving the wheels to any position, the amount of tilt MUST be limited by adjusting the limit stops on the gas cylinders to prevent the wheelchair from tipping onto the anti-tippers.

Operating Information

Unless otherwise noted, all service and adjustments should be performed while the wheelchair is unoccupied.

To determine and establish your particular safety limits, practice bending, reaching and transferring activities in the presence of a qualified healthcare professional before attempting active use of the wheelchair.

The necessary back angle (90°, 99°, 108°or 120°) MUST be selected before repositioning the wheels and adjusting the limit stops on the gas cylinders.

Both gas cylinders MUST be operational before using the wheelchair. DO NOT operate the tilt-in-space if only one of the gas cylinders is operational.

DO NOT operate the tilt-in-space if the trigger release levers and cables are not properly adjusted to ensure that the tilt-in-space is locked in place when engaged.

ALWAYS verify the userʹs hand position prior to activating the tilt-in-space feature. DO NOT remove the side shrouds (see below) which cover the tilt mechanism. Failure to observe this warning can result in serious injury.

Side Shroud for Wheelchairs

 

 

 

 

 

 

 

Side Shroud for

with Dual Point Arms

 

 

 

 

 

 

 

 

Wheelchairs with T-Arms

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ALWAYS wear your seat/chest positioning strap. Inasmuch as the seat/chest positioning strap is an option on this wheelchair (you may order with or without the seat/chest positioning strap), Invacare strongly recommends ordering the seat/chest positioning strap as an additional safeguard for the wheelchair user.

ALWAYS check foam grips for looseness before using the wheelchair. If loose, contact a qualified technician for instructions.

DO NOT traverse, climb or go down ramps or slopes greater than 9°.

NEVER leave the occupied wheelchair unattended at any time, especially on an incline.

DO NOT attempt to reach objects if you have to move forward in the seat.

DO NOT attempt to reach objects if you have to pick them up from the floor by reaching down between your knees.

DO NOT lean over the top of the back upholstery/seating system. This will change your center of gravity and may cause you to tip over.

DO NOT shift your weight or sitting position toward direction you are reaching as wheelchair may tip over.

Part No 1122134

15

Compass™SPT™

Image 15
Contents CompassSPT Compass SPT Limited CompassSPT Table of Contents Front Riggings BACK/SEAT Complete and mail the form on the next Register Your ProductProduct Registration Form Fold Here Cut Along Line Special Notes Signal Word MeaningTo Healthcare PROFESSIONALS/ASSISTANTS Label Locations Features Invacare Compass SPT Typical Product ParametersGeneral Guidelines Information for Healthcare Professionals/AssistantsStability Operating Information Weight Limitation Weight TrainingSAFETY/HANDLING Safety/Handling of WheelchairsStability and Balance Stability and Balance Coping With Everyday ObstaclesReaching, Leaning and Bending Forward Reaching, Leaning and Bending ForwardTipping Rear Wheel Configuration Only Reaching and Leaning BackwardsTipping Curbs Method 1 Wheelchair with Step Tubes Tipping Curbs Method 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair without Step TubeStairways Rear Wheel Configuration Only Tipping Front Wheel Configuration OnlyStairways Front Wheel Configuration Only Transferring To and From Other Seats EscalatorsSafety Inspection Checklist Safety Inspection ChecklistsInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting MechanicalSuggested Maintenance Procedures Maintenance/TransportingTransporting the Invacare Compass SPT Removing Installing/Removing Swingaway Front RiggingsInstalling Front Riggings60, 70 and 70 Taper Installing/Removing Lift-Off FootrestAdjusting Footrest Height Height Adjustment RangesModel PHW93 and PH904A Front Riggings 70 MFX, 90, 70 Lift and 90 Lift FootrestsInstalling Adjustable Angle Flip-up Footplate Hinge Installing Adjustable Angle Flip-up Footplate HingeAdjusting Adjustable Angle Flip-up Footplates Depth AdjustmentAngle Adjustment Reassembly Composite/Articulating Footplate Heel Loop ReplacementInstalling/Removing Elevating Legrests DisassemblyReplacing Sector Block Raising/Lowering the Elevating LegrestAdjusting Calfpad Depth Adjusting Footplate Height and Calfpad Height/DepthAdjusting the Footplate Height Adjusting Calfpad HeightReplacing Sector Block 12 Composite/Articulating Footplate Heel Loop Replacement14 Installing Impact Guards/Calf Strap/H-Calf Strap Installing Impact Guards/Calf Strap/H-Calf StrapArms Using/Adjusting Dual Point ArmsInstalling Armrest Adjusting ArmrestReplacing Dual Point Arm Clothing Guards Replacing Dual Point Arm PadInstalling/Removing T-Arms Installing T-ArmsRemoving T-Arms Adjusting T-Arm Height Adjusting The T-ArmsAdjusting T-Arm Depth Adjusting T-Arm WidthAdjusting T-Arm Sockets Adjusting T-Arm SocketsAdjusting T-Arm Transfer Assists And/or Side Guards Adjusting T-Arm Transfer Assists And/or Side GuardsBACK/SEAT Folding/Unfolding Back AssemblyInstalling Stroller Handle Installing and Removing a Seating SystemStroller Handle Adjusting/Replacing the Back Release Cord Adjusting the Back Release CordReplacing the Back Release Cord Replacing Installing/Replacing Seat Positioning StrapsInstalling/Replacing Chest Positioning Straps Installing/Replacing Chest Positioning StrapsEngaging Tilt-In-Space Tilt14 to 20-Inch Wide Wheelchairs Adjusting Trigger Release Cables21 to 22-Inch Wide Wheelchairs Adjusting Trigger Release Cables Replacing Caster/Fork Installing/Replacing Six or Eight-inch Caster/ForkInstalling Caster/Fork WheelsReplacing/Repairing Caster Tire/Tube Installing/Removing Rear WheelsQuick-Release Permanent Axle Adjusting the Quick-Release AxleReplacing Wheel Handrim Replacing/Repairing Wheel Tire/TubeWheel Locks and ANTI-TIPPERS Wheel Lock AdjustmentInstalling/Adjusting Anti-Tippers Installing Anti-TippersAdjusting Anti-Tippers Limited Warranty USA