Invacare PHW93 Composite/Articulating Footplate Heel Loop Replacement, Disassembly, Reassembly

SECTION 4—FRONT RIGGINGS

Composite/Articulating Footplate Heel Loop Replacement

NOTE: For this procedure, refer to FIGURE 4.8.

Disassembly

Composite.

1.Remove the hex screw and coved spacer that secure the lower footrest assembly to the swing away footrest assembly.

2.Remove the lower footrest assembly.

3.Remove the mounting screw and locknut that secure the heel loop to the footrest.

4.Slide heel loop off of the footrest.

Articulating.

1.Remove the mounting screws, washers and spacers that secure the heel loop to the articulating footplate.

Reassembly

1.Replace heel loop.

2.Reverse the disassembly procedures.

NOTE: When securing the heel loop to the footrest assembly, tighten mounting screw until the spacer is secure.

COMPOSITE FOOTPLATE

	Swingaway Footrest Assembly
	Hex Screw and
Philips	Coved Spacer
Screw	Lower Footrest	Philips
	Assembly
		Screw
Spacer
Heel		Washer
Loop		Heel
Locknuts		Loop
	Spacer

ARTICULATING

FOOTPLATE

FIGURE 4.8 Composite/Articulating

Footplate Heel Loop Replacement

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.9 on page 36.

Installing

1.Place elevating legrest on the outside of the wheelchair and insert mounting pin into the mounting tube.

2.Rotate elevating legrest toward the inside of the wheelchair until it locks in place.

NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place. 3. Repeat STEPS 1-3 for the other elevating legrest assembly.

Part No 1122134 35 Compass™SPT™