SECTION
Installing/Replacing Seat Positioning Straps
NOTE: For this procedure, refer to FIGURE 6.5.
Installing
1.Remove the hex screw and locknut that secures the back cane to the back plate.
2.Position the seat positioning strap against the back plate.
3.Install the hex screw through the seat positioning strap, coved spacers and back cane.
4.Securely tighten the seat positioning strap to the wheelchair with the locknut.
5.Repeat STEPS
Replacing
1.Remove the hex screw, locknut and seat positioning strap from the back plate of the wheelchair frame.
2.Discard existing seat positioning strap.
3.Install the new seat positioning strap to the wheelchair. Refer to Installing/Replacing Seat Positioning Straps on page 51.
Back Plate | Back Cane |
| Locknut |
Seat Positioning Strap |
|
Hex Screw | Coved Spacers |
|
FIGURE 6.5 Installing/Replacing Seat Positioning Straps
Part No 1122134 | 51 | Compass™SPT™ |