Invacare PHW93, PH904A manual Adjusting the Quick-Release Axle, Permanent Axle

Page 59

SECTION 8—WHEELS

Permanent Axle

NOTE: For this procedure, refer to FIGURE 8.3.

NOTE: To remove rear wheels, reverse this procedure.

1.Remove the permanent axles from the packaged container.

2.Install permanent axle through the rear wheel and axle plate.

3.Securely tighten the wheel to the wheelchair frame with locknut.

NOTE: Only 22-inch rear wheel is shown. All other wheels will install/remove in the same manner.

4.Repeat STEPS 2-3 for other rear wheel assembly.

5.Adjust the wheel locks. Refer to Adjusting the Quick-Release Axle on page 59.

Wheelchair Frame

Locknut

	Wheel
	Mounting
Permanent	Bracket
Permanent
Axle	Rear Wheel
	Rear Wheel

FIGURE 8.3 Installing/Removing Rear

Wheels - Quick-Release

Adjusting the Quick-Release Axle

NOTE: For this procedure, refer to FIGURE 8.4.

1.Remove wheel and quick-release axle from the wheelchair.

2.Depress detent pin in the quick-release axle and slide axle through the wheel hub.

3.Increase or decrease end play in the quick-release axle by adjusting the locknut on the end of the quick-release axle.

4.Reinstall wheel onto the wheelchair.

WARNING

Make sure detent pin and locking pins of the quick-release axle are fully released BEFORE operating the wheelchair.

Keep locking pins clean.

5.Release detent pin ensuring that the locking pins are fully released.

6.Repeat the above sections until the quick-release axle locks properly.

	Wheel
	(Reference)
Locking Pins	Locknut
	Locknut
	Detent
	Pin
Wheel	Quick-Release
Mounting	Quick-Release
Bracket	Axle

FIGURE 8.4 Adjusting the Quick-Release

Axle

Part No 1122134

59

Compass™SPT™

Image 59

Contents CompassSPT Compass SPT Limited CompassSPT Table of Contents Front Riggings BACK/SEAT Complete and mail the form on the next Register Your ProductProduct Registration Form Fold Here Cut Along Line Special Notes Signal Word MeaningTo Healthcare PROFESSIONALS/ASSISTANTS Label Locations Features Invacare Compass SPT Typical Product ParametersStability General GuidelinesInformation for Healthcare Professionals/Assistants Operating Information Weight Limitation Weight TrainingStability and Balance SAFETY/HANDLINGSafety/Handling of Wheelchairs Stability and Balance Coping With Everyday ObstaclesReaching, Leaning and Bending Forward Reaching, Leaning and Bending ForwardTipping Curbs Method 1 Wheelchair with Step Tubes Tipping Rear Wheel Configuration OnlyReaching and Leaning Backwards Tipping Curbs Method 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair without Step TubeStairways Rear Wheel Configuration Only Tipping Front Wheel Configuration OnlyStairways Front Wheel Configuration Only Transferring To and From Other Seats EscalatorsInspect/Adjust Initially Safety Inspection ChecklistSafety Inspection Checklists Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting MechanicalSuggested Maintenance Procedures Maintenance/TransportingTransporting the Invacare Compass SPT Removing Installing/Removing Swingaway Front RiggingsInstalling Front Riggings60, 70 and 70 Taper Installing/Removing Lift-Off FootrestAdjusting Footrest Height Height Adjustment RangesModel PHW93 and PH904A Front Riggings 70 MFX, 90, 70 Lift and 90 Lift FootrestsInstalling Adjustable Angle Flip-up Footplate Hinge Installing Adjustable Angle Flip-up Footplate HingeAngle Adjustment Adjusting Adjustable Angle Flip-up FootplatesDepth Adjustment Reassembly Composite/Articulating Footplate Heel Loop ReplacementInstalling/Removing Elevating Legrests DisassemblyReplacing Sector Block Raising/Lowering the Elevating LegrestAdjusting Calfpad Depth Adjusting Footplate Height and Calfpad Height/DepthAdjusting the Footplate Height Adjusting Calfpad HeightReplacing Sector Block 12 Composite/Articulating Footplate Heel Loop Replacement14 Installing Impact Guards/Calf Strap/H-Calf Strap Installing Impact Guards/Calf Strap/H-Calf StrapArms Using/Adjusting Dual Point ArmsInstalling Armrest Adjusting ArmrestReplacing Dual Point Arm Clothing Guards Replacing Dual Point Arm PadRemoving T-Arms Installing/Removing T-ArmsInstalling T-Arms Adjusting T-Arm Height Adjusting The T-ArmsAdjusting T-Arm Depth Adjusting T-Arm WidthAdjusting T-Arm Sockets Adjusting T-Arm SocketsAdjusting T-Arm Transfer Assists And/or Side Guards Adjusting T-Arm Transfer Assists And/or Side GuardsBACK/SEAT Folding/Unfolding Back AssemblyInstalling Stroller Handle Installing and Removing a Seating SystemStroller Handle Replacing the Back Release Cord Adjusting/Replacing the Back Release CordAdjusting the Back Release Cord Replacing Installing/Replacing Seat Positioning StrapsInstalling/Replacing Chest Positioning Straps Installing/Replacing Chest Positioning StrapsEngaging Tilt-In-Space Tilt14 to 20-Inch Wide Wheelchairs Adjusting Trigger Release Cables21 to 22-Inch Wide Wheelchairs Adjusting Trigger Release Cables Replacing Caster/Fork Installing/Replacing Six or Eight-inch Caster/ForkInstalling Caster/Fork WheelsQuick-Release Replacing/Repairing Caster Tire/TubeInstalling/Removing Rear Wheels Permanent Axle Adjusting the Quick-Release AxleReplacing Wheel Handrim Replacing/Repairing Wheel Tire/TubeWheel Locks and ANTI-TIPPERS Wheel Lock AdjustmentAdjusting Anti-Tippers Installing/Adjusting Anti-TippersInstalling Anti-Tippers Limited Warranty USA