Invacare PH904A, PHW93 manual Installing/Removing Swingaway Front Riggings

SECTION 4—FRONT RIGGINGS

SECTION 4—FRONT RIGGINGS

WARNING

After making adjustments, always make sure that parts are properly tightened BEFORE using the wheelchair.

Installing/Removing Swingaway Front Riggings

CAUTION

If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur.

NOTE: For this procedure, refer to FIGURE 4.1.

Installing

1.Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with hinge pins on the wheelchair frame.

2.Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.

3.Push the front rigging towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1-3 for opposite side of wheelchair.

5.If necessary, adjust the footrest height. Refer to Installing/Removing Swingaway Front Riggings on page 30

Hinge Pins

Telescoping Front Rigging Support

Removing

1.Pull the front rigging release lever and rotate the footrest outward.

2.Lift up on front rigging and remove from the wheelchair.

3.Repeat STEPS 1-2 for opposite side of wheelchair.

Front Front

Rigging Rigging

Release Hinge

Lever Plate

FIGURE 4.1 Installing/Removing Swingaway

Front Riggings

Compass™SPT™ 30 Part No 1122134