SECTION
Replacing/Repairing Caster Tire/Tube
WARNING
Replacement of caster tire or tube MUST be performed by a qualified technician.
CAUTION
As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and should be replaced.
Installing/Removing Rear Wheels
Quick-Release
NOTE: For this procedure, refer to FIGURE 8.2.
NOTE: To remove rear wheels, reverse this procedure.
1.Push in the detent pin of the
2.Push in the tip of the
WARNING
Make sure detent pin and locking pins of the
The locking pins MUST be protruding past the inside of the axle mounting plate for a positive lock.
Keep locking pins clean.
3.Ensure quick release axle locking pins are properly engaged and secure in the axle mounting plate by pulling the rear wheel away from the wheelchair frame. If the locking pins DO NOT engage or there is too much movement of the rear wheel assembly in a back and forth position refer to Adjusting the
4.Repeat STEPS
|
| Wheelchair |
|
| Frame |
Locking |
|
|
Pins |
|
|
|
| Wheel |
|
| Mounting |
Detent |
| Bracket |
| Rear Wheel | |
Pin | ||
|
|
5. Adjust the wheel locks. Refer to Wheel | FIGURE 8.2 Installing/Removing Rear | |
Lock Adjustment on page 61. | ||
Wheels - | ||
|
Compass™SPT™ | 58 | Part No 1122134 |