Invacare PHW93, PH904A manual Installing/Removing Lift-Off Footrest, Adjusting Footrest Height

SECTION 4—FRONT RIGGINGS

Installing/Removing Lift-Off Footrest

NOTE: For this procedure, refer to FIGURE 4.2.

Installing

1.Insert the footrest assembly mounting pins into the mounting tube of the wheelchair frame.

2.Repeat STEP 1 for the other footrest assembly.

3.If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 31.

Removing

1.Push the footrest release lever inward and lift footrest upward.

2.Repeat STEP 1 for opposite side, if necessary.

Mounting Pin
Footrest Release	Footrest
	Assembly
Lever
Wheelchair
Frame	Footplate
Mounting Tube

FIGURE 4.2 Installing/Removing Lift-Off

Footrest

Adjusting Footrest Height

Height Adjustment Ranges

FOOTREST TYPE	ADJUSTMENT RANGE
60°	13-17 inches
70°	13-17 inches
90°	5-8 inches
90°	5-11 inches (with 3-inch extension)

60°, 70° and 70° Taper

NOTE: For this procedure, refer to FIGURE 4.3 on page 32.

1.Remove the footrest from the wheelchair. Refer to Installing/Removing Swingaway Front Riggings on page 30.

2.Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube until the desired footrest height is achieved.

3.Reassemble the hex screw and coved spacer through the footrest upper support and mounting tube (FIGURE 4.3).

Part No 1122134 31 Compass™SPT™