Invacare 70 MFX, 90, 70 Lift and 90 Lift Footrests, Model PHW93 and PH904A Front Riggings

SECTION 4—FRONT RIGGINGS

4.Securely tighten the hex screw and coved spacer.

5.Install the footrest assembly onto the wheelchair. Refer to Installing/Removing Swingaway Front Riggings on page 30.

6.Repeat STEPS 1-5 for the opposite side of the wheelchair, if necessary.

Hex Screw	Footrest Upper
	Support
Coved	Mounting
Spacer	Tube
Footrest

FIGURE 4.3 Adjusting Footrest Height -

60°, 70° and 70° Taper

70° MFX, 90°, 70° LIFT and 90° LIFT Footrests

NOTE: For this procedure, refer to FIGURE 4.4.

1.Remove any accessories that are attached to the footrests.

2.Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support.

3.Reposition the footplate to the desired height.

4.Reinstall the socket bolt through the mounting holes of the footplate and footrest support.

WARNING

DO NOT overtighten socket bolt and locknut. Footrest MUST be able to rotate upward from the horizontal to the vertical position.

5.Secure the footplate to the footrest support with the coved washer and locknut.

Footrest Support

Height

Adjustment

Holes

Locknut Socket Bolt

Footplate

FIGURE 4.4 Adjusting Footrest Height -

70° MFX, 90°, 70° LIFT and 90° LIFT

Footrests

Model PHW93 and PH904A Front Riggings

NOTE: For this procedure, refer to FIGURE 4.5 on page 33.

1.Remove any accessory from the footrest(s).

2.Remove the footrest from the wheelchair. Refer to Installing/Removing Swingaway Front Riggings on page 30.

NOTE: Lay footrest on a flat surface to simplify procedure.

Compass™SPT™ 32 Part No 1122134