Invacare PH904A, PHW93 manual Installing/Removing T-Arms, Installing T-Arms

SECTION 5—ARMS

2.Replace the existing clothing guard with the new clothing guard and securely tighten with the existing hardware.

3.Repeat STEPS 1-2 for the opposite side if necessary.

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 5.3.

Installing T-Arms

1. Position the T-Arm over the T-Arm socket on the wheelchair frame.

NOTE: Make sure the locking lever is towards the front of the wheelchair.

2.Slide T-Arm into T-Arm socket until the locking lever is in the slot in the T-Arm socket and an audible “click” is heard.

3.Pull up on T-Arm to make sure T-Arm is locked in place.

NOTE: If the T-Arm does not slide in the T-Arm socket as desired, adjust the T-Arm socket. Refer to Adjusting T-Arm Sockets on page 45.

4.Adjust the T-Arm for desired height, width and depth, if necessary. Refer to Adjusting The T-Arms on page 43.

5.Repeat STEPS 1-4 for opposite side of wheelchair.

Removing T-Arms

1.Press the locking lever in and lift the T-Arm straight up and out of the T-Arm socket.

NOTE: If the T-Arm does not slide up and down in the T-Arm socket as desired, adjust the T-Arm socket. Refer to Adjusting T-Arm Sockets on page 45.

2. Repeat STEP 1 for opposite side of the

T-Arm

Wheelchair

wheelchair.

Frame

Locking Lever (towards the front of

T-Armthe wheelchair) Socket

Slot

FIGURE 5.3 Installing/Removing T-Arms

Compass™SPT™ 42 Part No 1122134