Omega 24, 27, 25, 26 manual To Recall Outputs, To Erase Set-Up Locations Calibrator Mode

To Recall Outputs:

1.While in the CALIB OPR mode, set-ups saved earlier in memory can be recalled to program the calibrator output. First depress the RECALL key to recall a set-up.

1.Note that the RCL annunciator turns on, OPR turns off, and all memory locations annunciators are blanked.

2.Next hit the key with the number corresponding to the desired memory location. The corresponding annunciator turns on, and the LCD updates to show the new calibrator setting.

eg. RECALL 8

3.Several stored set-ups can be randomly recalled by a key sequence such as:

eg. RECALL 6 eg. RECALL 3 eg. RECALL 9 eg. etc.

4.To return the unit to the CALIB OPR mode after recalling the last set-up, hit the OPR key.

NOTES:

•Any other key except ON/OFF and CLEAR will also return the OPR mode.

•Set-ups recalled from unused locations will display and output 0°.

•Calibrator set-ups can be recalled even when the unit is func- tioning in the meter mode. The same 10 storage locations are shared in both meter and calibrator modes.

•Readings stored in memory while operating as a METER, can be recalled in the CALIB mode. In this unusual application, the unit generates calibrator outputs that simulate earlier stored meter inputs.

To Erase Set-Up Locations (Calibrator Mode):

1.Individual set-up locations can be erased by recalling the location followed by a hit to the CLEAR key.

eg. RECALL 5 eg. CLEAR

21