CONAIR
MARTIN
6.Operation and daily maintenance
6.1Starting and stopping
The start and stop functions are controlled by a
NOTE: The granulator should not be stopped until it has finished grinding all the material in the hopper and cutter housing. Any remaining material can slow down the rotor when it is re- started which can overload the motor and trigger the overload protector.
/tidräknare/: time counter
/huvudbrytare/: main switch
/nödstopp/: emergency stop
/paus/pulsrelä/: pause/pulse relay
6.2Inspection
There should not be any material in the granulator when the inspection is to be carried out.
6.2.1Daily inspection
•Emergency stop. Check the emergency stop function by starting the granulator and then stopping it using the emergency stop button. The emergency stop is reset by turning the emergency stop button in the direction of the arrow. The machine can then be
6.2.2Weekly inspection
•Cables. Inspect all cabling in the machine to see that there is no wear or other damage. For reasons of personal protection, damaged parts should be replaced immediately.
•Safety switches. There are 2 safety switches, 1 for the locking clamp by the screw feed, and 1 for the screenbox:
Screenbox: Check the safety switch by loosening the granule bin as described in chapter 5.2. It should not be possible to start the granulator until the hoisting mechanism's bar has been set in a vertical position after the granule bin has been put into place.
Hopper: Open the hopper as described in chapter 5.2, but close and lock the granule bin. Check the safety switch to the hopper by starting the granulator. It should not be possible to start the granulator until the hopper is closed and the locking clamp is back in position.
0 5 - 1 5 - 9 6 | 7 9 | 10 |