Conair CMA-79 Pause/pulse relay when emptying with Air-veyor, Delay time interval T2 the time

Page 26

CONAIR

MARTIN

11.1.2Pause/pulse relay when emptying with Air-veyor

In those cases when emptying of the granule bin with an air veyor has been chosen, the pause/pulse relay should be cancelled to prevent a glut in the granule bin.

When delivered, the relay is preset as follows:

T1 = range 1 - 10 m	A
T2 = range 6 - 60 s
where
Pause time T1 (the time the air
veyor is idle) is selected using
switches (A) and (B). Then the
time is set using the handwheel
Toff = T1.	C
Delay time interval T2 (the time
the air veyor is working) is
selected using switches (C) and
(D). Then the time is set using
the handwheel Ton = T2.

B

D

A Setting of: seconds, minutes or hours

B Setting of multiples: x0.1 or x1

C Setting of: seconds, minutes or hours

D Setting of multiples: x0.1 or x1

0 5 - 1 5 - 9 6

7 9

26

Image 26

Contents Manual Contents Introduction Data Technical specificationsDimensions Serial NumberFunctional description OverviewSafety system Safety regulations = WARNING! Risk of being cut or caught in the machineryTwo hours after first start InstallationPre-start checks Opening and closing the hopper and screenboxElectrical connection HopperInspection Operation and daily maintenanceStarting and stopping Daily inspectionOr at least once every 300 hours CleaningTrouble-shooting If the granulator does not startChanging the fixed and rotating knives ServicingChanging the knives Assembling the rotating knives Assembling the upper fixed knifeSharpening the fixed and rotating knives Sharpening the knivesOverview Fixed knivesRotating knives Assembling Disassembling/assembling the screwDisassembling Lubrication Spare parts list 1a 79, Diagram 1b 79, Table Pos Qty2 79, Knives, fixed and rotating Electrical scheme Layout Options 11.1.1 79, Air-veyor Pause/pulse relay when emptying with Air-veyor Delay time interval T2 the timeSetting the sensitivity Level control, capacitiveTransporting and storing Storing