Conair CMA-79 manual Spare parts list, Overview

Page 18

CONAIR

MARTIN

8.Spare parts list

8.1Overview

Only use spare parts from CONAIR MARTIN when replacing machine parts. Orders should go to the representative in the country where the machine was purchased.

When ordering, the following should be specified:

machine designation, as specified on the machine plate

serial number, as specified on the machine plate

article number, as specified in the spare parts list

quantity, as specified in this spare parts list.

Each module illustrates a particular part of the granulator.

The granulator is divided into the following modules:

 

 

Page

8.1.1a

79, Diagram

19

8.1.1b

79, Table

20

8.1.2

79, Knives, fixed and rotating

21

0 5 - 1 5 - 9 6

7 9

18

Image 18
Contents Manual Contents Introduction Data Technical specificationsDimensions Serial NumberFunctional description OverviewSafety system Safety regulations = WARNING! Risk of being cut or caught in the machineryTwo hours after first start InstallationPre-start checks Opening and closing the hopper and screenboxElectrical connection HopperInspection Operation and daily maintenanceStarting and stopping Daily inspectionOr at least once every 300 hours CleaningTrouble-shooting If the granulator does not startServicing Changing the knivesChanging the fixed and rotating knives Assembling the rotating knives Assembling the upper fixed knifeSharpening the fixed and rotating knives Sharpening the knivesOverview Fixed knivesRotating knives Disassembling/assembling the screw DisassemblingAssembling Lubrication Spare parts list 1a 79, Diagram 1b 79, Table Pos Qty2 79, Knives, fixed and rotating Electrical scheme Layout Options 11.1.1 79, Air-veyor Pause/pulse relay when emptying with Air-veyor Delay time interval T2 the timeSetting the sensitivity Level control, capacitiveTransporting and storing Storing