Conair CMA-79 manual Options, Overview

Page 24

CONAIR

MARTIN

11.Options

11.1Overview

Only use spare parts from CONAIR MARTIN when replacing machine parts. Orders should go to the representative in the country where the machine was purchased.

When ordering, the following should be specified:

•machine designation, as specified on the machine plate

•serial number, as specified on the machine plate

•article number, as specified in the spare parts list

•quantity, as specified in this spare parts list.

Each module illustrates a particular part of the granulator.

The granulator is divided into the following modules:

The following options are described:

11.1	Overview	24
11.1.1	79, Air-veyor 32	25
11.1.2 Pause/pulse relay when emptying with Air-veyor		26
11.1.3	Level control, capacitive	27

0 5 - 1 5 - 9 6

7 9

24

Image 24

Contents Manual Contents Introduction Technical specifications DimensionsData Serial NumberFunctional description OverviewSafety system Safety regulations = WARNING! Risk of being cut or caught in the machineryInstallation Pre-start checksTwo hours after first start Opening and closing the hopper and screenboxElectrical connection HopperOperation and daily maintenance Starting and stoppingInspection Daily inspectionCleaning Trouble-shootingOr at least once every 300 hours If the granulator does not startServicing Changing the knivesChanging the fixed and rotating knives Assembling the rotating knives Assembling the upper fixed knifeSharpening the knives OverviewSharpening the fixed and rotating knives Fixed knivesRotating knives Disassembling/assembling the screw DisassemblingAssembling Lubrication Spare parts list 1a 79, Diagram 1b 79, Table Pos Qty2 79, Knives, fixed and rotating Electrical scheme Layout Options 11.1.1 79, Air-veyor Pause/pulse relay when emptying with Air-veyor Delay time interval T2 the timeSetting the sensitivity Level control, capacitiveTransporting and storing Storing