Miele T 8164 WP Fine filter, Removing the fine filter, Cleaning the fine filter

Page 27

Cleaning and care

Fine filter

When to clean

The fine filter only needs to be cleaned when the Clean out airways indicator light comes on.

The indicator light will go out when the door is opened and closed again.

Removing the fine filter

On the front left of the tumble dryer:

Press to open the access panel for the fine filter (see arrow).

The panel will spring open.

Pull the filter out by the handle.

Pull the handle out of the filter.

Cleaning the fine filter

Clean the fine filter thoroughly under running water.

Then squeeze it thoroughly.

It must not be replaced dripping wet as this can cause a fault.

Use a damp cloth to remove any fluff from the handle

27

Image 27
Contents Operating instructions Heat-pump dryer 8164 WP Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Contents Correct application Safety with children Technical safety Page Correct use Page Page Page Accessories Control panel Operating the tumble dryerDisplay shows Before using for the first timeDisplay h min Drum lightingDrying Care symbolsLaundry care Tips on drying Turn on the tumble dryer How to dry correctlyBrief instructions  Sort the laundry Remove the laundry when the programme has finished  Select a programme Start the programme Programme duration Changing the programme sequenceOnce a programme has started Adding or removing laundry after a programme has startedHand iron, Machine iron Programme overviewCottons Max. load 7.0 kg Normal+, Normal Normal Gentle tumbleMin cool air Minimum iron Max. load 3.5 kg Normal, Hand ironAutomatic plus Max. load 3.5 kg Timed drying Max. load 7.0 kg Min warm airWoollens Max. load 2.0 kg Gentle smoothing Max. load 1.0 kgEmptying the condensed water container Cleaning and careWhen to clean the fine filter When to clean the fluff filtersCleaning the fluff filters When to cleanCleaning them whilst dry Cleaning them with water Replacing them Cleaning the fine filter Fine filterRemoving the fine filter Cleaning the cover for the fine filter Replacing Tumble dryerCheck and fault messages Problem solving guideThere is a build-up of fluff in the airways Problem solving guideUnsatisfactory drying results Other problems Before starting another programme Problem Cause and remedy Drying processEven switches off Goes on too long orChanging the lamp Dryer basket After sales serviceGuarantee RepairsFront view Installation and connectionTransporting the dryer Rear viewInstallation Before moving the tumble dryer again e.g. when moving house Levelling the dryerWasher-dryer stack Electrical connection U.K Non-rewireable plugs BSAutomatic plus Consumption dataTechnical data Page Settings To check the setting Laundry will be drier  Carry out steps -  Switch the dryer off after checking Anti-crease  Anti-crease action off  Anti-crease 1 h Anti-crease 2 h Switching the buzzer on/off Clean out airways indicator light will also flash once Not in current programme factory default setting StandbyOff  Off  On  Not in current programme factory default settingGentle smoothing Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/4613 Nr 557 600