Miele T 8164 WP Problem solving guide, There is a build-up of fluff in the airways

Page 31

 

Problem solving guide

 

 

 

 

Problem

Cause and remedy

The Start indicator light

The dryer is in standby mode. This is a normal

flashes slowly and the

function and does not indicate a fault.

display is dark.

 See "Standby" in "Settings".

The Clean out airways

There is a build-up of fluff in the airways.

indicator light comes on

 Clean the fine filter.

at the end of a

 Clean the fluff filters

programme.

 Open and close the door while the dryer is

 

switched on. The indicator light will go out.

 

 

The programme is

An excessive amount of fluff has built up.

cancelled and the Clean

 Clean the fine filter, fluff filter and heat exchanger.

out airways indicator

 Open and close the door while the dryer is

light comes on.

switched on. The indicator light will go out.

 

 

Bars flash in the display

The programme has finished but the laundry has not

at the end of a

yet cooled down.

programme:

 Either remove the laundry and spread it out to cool

.........

down or leave it in the tumble dryer to cool down

 appears in the

during the cooling phase.

The programme selector has been moved.

display

 Select the original programme. The time remaining

 

will appear in the display again.

 

 

31

Image 31
Contents Operating instructions Heat-pump dryer 8164 WP Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Contents Correct application Safety with children Technical safety Page Correct use Page Page Page Accessories Control panel Operating the tumble dryerDisplay shows Before using for the first timeDisplay h min Drum lightingDrying Care symbolsLaundry care Tips on drying Turn on the tumble dryer How to dry correctlyBrief instructions  Sort the laundry Select a programme  Remove the laundry when the programme has finished Start the programme Programme duration Changing the programme sequenceOnce a programme has started Adding or removing laundry after a programme has startedHand iron, Machine iron Programme overviewCottons Max. load 7.0 kg Normal+, Normal Normal Gentle tumbleMin cool air Minimum iron Max. load 3.5 kg Normal, Hand ironAutomatic plus Max. load 3.5 kg Timed drying Max. load 7.0 kg Min warm airWoollens Max. load 2.0 kg Gentle smoothing Max. load 1.0 kgEmptying the condensed water container Cleaning and careWhen to clean the fine filter When to clean the fluff filtersWhen to clean Cleaning the fluff filtersCleaning them whilst dry Cleaning them with water Replacing them Fine filter Cleaning the fine filterRemoving the fine filter Cleaning the cover for the fine filter Replacing Tumble dryerCheck and fault messages Problem solving guideThere is a build-up of fluff in the airways Problem solving guideUnsatisfactory drying results Other problems Before starting another programme Problem Cause and remedy Drying processEven switches off Goes on too long orChanging the lamp Dryer basket After sales serviceGuarantee RepairsFront view Installation and connectionTransporting the dryer Rear viewInstallation Levelling the dryer Before moving the tumble dryer again e.g. when moving houseWasher-dryer stack Electrical connection U.K Non-rewireable plugs BSAutomatic plus Consumption dataTechnical data Page To check the setting Settings Laundry will be drier  Carry out steps -  Switch the dryer off after checking  Anti-crease action off  Anti-crease 1 h Anti-crease Anti-crease 2 h Switching the buzzer on/off Clean out airways indicator light will also flash once Standby Not in current programme factory default settingOff  Off  On  Not in current programme factory default settingGentle smoothing Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/4613 Nr 557 600